line level converter. Then you unhook the speakers, hook the wires up the the converter, then hook the converter up to the amp, then hook the amp up to the speakers. Please leave good feedback! If the
Question about PCA250 Car Audio Amplifier
output from the spearker. My recommendation is to get a line level converter. Go to a car audio shop or even best buy and specifically ask for a line level converter. It will have speaker wires in and
Question about D5-1200.1 Car Audio Amplifier
...wire) using a line level converter. These convert the High level speaker wire output into low level RCA output that is accepted by your amplifier. Get a good one Pacific Accessory Corporation (PAC) ...
...as you have an output for subs also. You could try a line converter to change the RCA lines to speaker wire connections. Not sure if the output would be enough to power a speaker but it's worth a
...Line Output Converter to it. They look like this - ...
in" on the amp and you can adjust the line level converter for output voltage ( increasing the level increases the volume before the amp, so be easy on the adjustments or you could blow your speakers.
Question about Pac Sni-35 Line Output Converter Add An Amplifier Sni35
...Line Output converter How do I hook up to factory stereo You can get the signal wired behind the radio or if it is more convenient you can tap into the rear speaker wires in the colums in the rear of ...
Question about Pac Sni-35 Line Output Converter Add An Amplifier Sni35
...line-level-to-mic-level which uses a 100 ohm resistor and a 10 k resistor. For stereo you will need 2 of these, the outer case of the wire is shared by both circuits, and will play the role of the ...
...Line RCA outputs for your amplifier The converter i bought also gives you a "remote wire" output which tells your Amp when the car is on so it doesn't drain your battery, if you get a converter ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions