Questions & Answers for: Remington how do you tighten a chain

...tighten the chain by moving the bar or making it longer or shorter. Adjust that so that the bar is as short as possible and put the chain back in place. Then tighten that feature till the chain is ...

...chain back on the bar in the guide slot. Then you tighten that screw to the point that you can still push the chain around the bar (wear gloves) and there is very little slack under neath. Then you ...

...tighten chain .. too droopy. i am a 66 yr old female i do not know how to tighten my elec. chain saw chain it isnt too droopy just a small amount. i tried to tighten the screws where the man at a ...

...the bar meets the body of the saw there is an adjustment lug that will either push the bar outward tightening the chain or may be retracted allowing slack in the chain. When backed off (loosened) ...

...the bar towards the main body of the saw just enough to slip the chain back on then tighten it carefully, just tight enough to keep the chain on but not so tight that the chain doesn't rotate

[email protected] THANKS after reinstalling the chain,make sure the two guide bar bolts are loose, Using a screwdriver,turn adjustment screw to tighten chain to bar. Re-tighten guide bar ...

...tighten the chain. Fit the cleaned cover over the case and make sure the adjustment tang drops into one of the large holes in the bar end--you may have to back off the adjustment screw several turns ...

...tighten the screw and loosen the chain and then make it tight again after everything is together, so experiment with the process of tightening and loosening the screw. (Note, the loosening and ...

and clean it. no manual. and chain loose. how to tighten it? Remove fasteners from plate holding bar in place, bar and chain can be removed at this point. To tighten find tension screw, turn clockwise

...Tighten chain Jo: Unplug the saw. Lay the saw on it's side so the chain and bar are up (lay it on 4X4 blocks or something similar so the motor housing doesn't make the saw rock back and forth) Loosen ...