scsi tape drive Hello, My scsi tape drive is not working? It is external HP 160 dat drive. It is brand new? Hello Rivcr, 1. Check for a terminator on the back of the scsi unit. 2. Make sure you have ...
Question about Cables & Converters ACK-68I3-LVD-LP-Round-U320 Int ULTRA320 SCSI 3-Position Cable (2017100)
SCSI Inquiry Command Failure w/Tandberg TDC 4120 tape drive All, I am trying to solve a SCSI bus problem and could use some help to determine if the problem is the drive, or the configuration of the ...
29160lp sees cd drives but not HDs At boot 29160lp sees the cd drives but not the hdds. I checked the ribbon to the card and drives, all seems well. HD Drive activity lights blink at boot but not ...
Question about AppleCD 600e (M3958LL/A) CD-ROM Drive
missing, also make sure there is a termination end on the drive as scsi will not read without being terminated. You may have to search the internet a bit for an old macintosh classic driver, make sure
Question about AppleCD 600e (M3958LL/A) CD-ROM Drive
...Try changing the SCSI address number on the scanner to a different one and make sure the chain is terminated properly. If there are multiple SCSI devices in the chain, disconnect all the others ...
...terminate a 50-pin ultra scsi drive if it is the only drive on the cable and there's only room for one device? Eg. there's only two interfaces, one for the the drive and one for the card. Usually, ...
terminate the scsi? pls help!!! Small Computer System Interface, this is part of the computer that need driver to installed. All you need is to installed all the driver on your laptop and it won't ask
I am running XP Pro SP3 and have installed a SCSI card and software for the scanner. When opening the utility I get error #5 cannot confirm scanner connection. Please confirm scanner's connection and ...
Getting the following error repeatedly: A parity error was detected on \Device\RaidPort1. Source: adpu320 Event ID: 5 Any help would be greatly appreciated... Any "Parity Error" is from a ...
UMAX PowerLook 2100xl scanner termination connected to PowerMac G5 but Nikon 4 software can't see the scanner. Apple profile shows SCSI target device@6 UMAX PowerLook etc... Instructions for scanner ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions