Questions & Answers for: Uniden swing set

Question about PC68XL (40 Channels) 2-Way Radio

2 Answers

...swing to whatever it went to(it ended up at 3/4 swinging to 7),I have a small amp 2 mrf455's this setup does key the amp and has my 90 watts swinging from about 18 to the 90... I do use a power ...

Ad

Question about PRO510XL 40-Channels Base CB Radio

1 Answer

...diode. You won't be over modulated. That will bring you modulation up and your peak watts. it will swing to maybe 15-20 watts peak. That alone with make the radio louder. You really don't need to ...

Ad

Question about PRO510XL 40-Channels Base CB Radio

1 Answer

...doing just these two things and maybe a little adjusting you should be able to deadkey 2 watts and swing to 18 watts with just that cheap stock mic. if you change the final transistor I've seen them ...

Question about Bearcat Pro PC68XL 40-Channels Base CB Radio

2 Answers

SWING ON THE METER. it sound that a can has been set of balance, or the output  transister has crashed. did you up grade the output before ajusting for more output. Has anything changed with your

Question about Bearcat Pro PC68XL 40-Channels Base CB Radio

2 Answers

There is no such Modulation to on a cb radio to get over 8 watts dead key and no more then 8 watts swing. All Cb shops are the milk men. Some Cb shops do not know this and some do. I have heard of cb

Question about Bearcat Pro PC68XL 40-Channels Base CB Radio

1 Answer

recieving but not transmitting This could be several different problems...as simple as a bad solider to you're voltage regulator gone bad.If the meter on the front of your radio is swinging backwards ...

Question about Bearcat Pro PC68XL 40-Channels Base CB Radio

1 Answer

...swing mod. If you are trying to adjust your dead key, it sounds like you are trying to run a linear amplifier. If that is the case, you should probably set your dead key to around 2 watts. Most ...

Question about PC68XL (40 Channels) 2-Way Radio

1 Answer

...(-) toward final across JUMPER staple near Final Transistor in back. Use meter(adjust to best swing) spread back coils,remove L10,L20 slugs or adjust them to top. The only radio that clips ...

Question about Bearcat Pro PC68XL CB Radio

1 Answer

L8-10, where do i find them on my board clip D-9 diode for max mod. tune slugs L-8 and L-10 for max swing near back of radioL-8 has factory wax remove very careful tune slug out for max wattage output

Question about Bearcat Pro PC68XL CB Radio

1 Answer

...final(without proper discharge 100 ohm resistor). I turned back power to 1 1/2 watts to 4 swing a Tx tuning slug *redpaint on it. I let it talk on low key an when i speak it jumps to 4 or 5 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Uniden Radio Communication Experts

John
John

Level 2 Expert

510 Answers

eradiostore
eradiostore

Level 3 Expert

1672 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Are you an Uniden Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...