Questions & Answers for: Jura Capresso stuck solenoid

Capresso C1300 LCD stays on stating "Hot water cycle necessary" Jura-Capresso C1300 machine will not make coffee. UNIT GOT STOCK IN THIS STAGE DISPAY READ: HOT WATER CYCLE NECESSARY. UNIT DOES NOT ...

...still does it. I'm guessing there is a solenoid that is stuck, but I don't know where it might be. you need to clean / lubricate. See my post on  ...

my jura capresso says system fill...it makes a lot of noise what is the system fill and why does it make noise? System fill is usually when the machine auto solenoid fill valve is putting water into ...

...solenoid valve.. Turns out it cost nothing to repair, but you will need to dismantle the machine a bit. There is a plastic pipe behind the front panel, which pivots like a see-saw, and this is what ...

...solenoid is stuck (mechanical issue) 2) solenoid failed or 3) power to the solenoid failed. In my case it was 1) solenoid was stuck. I used a needle nose pliers to grab the nub of the solenoid push ...

water in grounds container The coffee solenoid valve return side is blocked from dry coffee. You can use cleaning tublets to clean some times the coffee group. With this it might be unblocked if not ...

...calcified and seized. I soaked it in boiling water and pressed on it gently several times and it unstuck. I put it all back together again and presto! Good luck Hi, Great solution - solved 80% of

My Jura S9's grinding unit clogged (due to Peete's beans) My Jura S9's grinding unit clogged (due to Pete's coffee beans that were apparently too gooey. Seems like this shouldn't be so easy to do, BTW

The solenoid valve needs to be replace - part nr. U35D , 120v/60Hz, 8VA, manufacturer ACL Italy , art. no. 24799A. Please let me know where I can buy a replacement part - thanks! Adina ...

...only but water full help nothing work only fill water display check small float in tank is not stuck in the down position There is a floating magnet on the inside wall of the water tank. See if ...