Questions & Answers for: Onkyo signal system

...system up to 40 it shuts off after a few minutes. None of the other connections have this issue. Please give guidance as I have NO clue. Thank you kindly. Shawn. Most systems like this have what is ...

...system went through the automatic setup, I heard the test sound go to each of the 7 speakers. Right now I have speaker set A chosen. It must be about the sound quality need of your amplifier. The ...

...signal and Dolby 5.1 will sound better through the surround sound theater system. I have not found an absolute solution to this yet, but I am willing to not get sound through the lousy TV speakers in ...

...system and shutting all components down as usual, the video quit working. The next morning upon start up, we could hear the cable tv through the speakers, but the tv showed the message "weak signal". ...

...signal from my Onkyo TX SR 875 to my Panasonic TV. The TV is connected to the HDMI out on the amp. The system works perfectly initially but after it has been on for about half an hour and I try to ...

...an HDMI socket. You might have to apply settings to the socket to allow it to pass sound or video signals. Ideally the TV should be connected via a optical cable, with the TV set to send out Dolby ...

...dvd hdmi cable into my receiver (7.1 ch home theater syst.-HT-s5100) to the tv and i receive no signal on my tv. if i hook up the hdmi cable directly from my dvd to my tv i have a signal. unhook ...

...system - orange, and red&white. Often, when you can hear a low-level signal on an input, it's due to 'leakage' from another input, and it's my hunch that the cable receiver is sending audio through ...

...system uses a remote control, you may need to adjust the subwoofer out signal setting or turn on the sub in a menu, and on many systems, you can only access those settings via a remote control (you ...

R which has a Cable IN jack then use audio out to my MY RECEIVER which repoduces the TV & audio signal, I then set my TV to the S-video mode to watch