Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...valves be set? Without seeing a picture of the setup it is nearly impossible to tell how the valves should be set. The bubbles problem is most likely the blower, or a check valve problem. Upgrade you ...
Question about Series Cl460 Filter Cartridge, 115 Sq. Ft
...VALVES SET PROPERLY WITH VAC NEED INFORMAION HOW TO SET INLET OR OUTLET VALVES WHEN VAC IS ATTACHED TO CLEAN POOL WHEN ATTACHED IT IS FLOATING OR BEING PULLED NEED HELP Here is a copy of the Jandy ...
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...valves in spa mode, there should be a toggle switch on the valve actuators. You can set the switches to the middle position and that will lock them in that position. You will probably have to ...
Question about Aqualink Rs4 One Touch Control System Control System
valves (pool and solar) rotate 180 degrees correctly bu the spa valve continues to rotate. I thout it was just a valve problem but when I flick the toggle switch on the valve to the on 2 position, the
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...the top of the JVA by removing the six small screws. Once it is open than you can loosten the set nut on the shaft and adjust the valve to the full spa position. The cam on the shaft will need ...
Question about TELEDYNE LAARS GAS VALVE, PROPANE W/STREET ELL
Unit cycles in and out before reaching set temp Problem with the thermocoupler its not producing a minivolt of 250 plus that is needed to open the main gas valve http://www.laarsman.co.uk Miles
Question about TELEDYNE LAARS GAS VALVE, PROPANE W/STREET ELL
...valves should act when in the spa and the pool mode then getting the switches set right is simple. I hope this helps. Spot on answer! The operators that John referred to are actually called Valve ...
Question about Aqualink Rs4 One Touch Control System Control System
valves do not actuate from panel but do with switch on valve make sure valves are activated go into system set up go to jvas then assign in and out make sure you have a pool and spa combo bezel board
Question about Lite 2 Natural Gas Pilot Light Heater
I have Laars Lite2 125k BTU Propane. pilot stay lit and after some time hear click sound in gas valve but it will not fired up and also pilot goes off right away. It sounds like you need to replace ...
Question about Aqualink Rs4 One Touch Control System Control System
...valves are set as follows wih a few minor variations.....Pool mode- sucks from pool skimmer and or pool vac line and returns water to both the pool and spa.Spa mode - self contains the spa , meaning ...
Usually answered in minutes!
193 Questions
170 Questions
177 Questions
72 Questions