Questions & Answers for: how do i set my valves

Ad

apparently valve not working, how can I check it? Radiator nor warming up whatever setting. There is no air lock. sounds as though the thermostatic radiator valve is stuck although the valve settings ...

Ad

Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System

1 Answer

...valves be set? Without seeing a picture of the setup it is nearly impossible to tell how the valves should be set. The bubbles problem is most likely the blower, or a check valve problem. Upgrade you ...

Ad

...set #5 valves, turn the engine till #6 valves rock, set # 3 valves, turn the engine until #3 valves rock, set # 6 valves, turn engine till #5 valves rock, set # 2 valves, turn engine till #1 valves ...

Question about Yardman Riding Lawn Mower 38in Deck 12 12 Hp

1 Answer

...set valves on a riding mower with a 13.5 h.p. engine a briggs over head valve engine turn the engine til one valve opens set the other valve to .006 turn til the other valve opens then set the closed ...

Question about HT101 Pole pruner

1 Answer

...set the air gap between the flywheel and the ignition unit which should be around 0.25mm (0.010") Excessive air gap will retard the ignition timing. Unless you've had the engine apart, the valve ...

Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1

1 Answer

setting specs for 1996 geo tracker 16valve valve lash need to know the spec settings for valve adjustment. 1996 geo tracker 16 valve .008 to .009 factory set ,i set mine at .007

Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1

1 Answer

...set by either cutting out valve seats with a special cutter tool (to DECREASE clearances) or grinding the end of the valve (to INCREASE clearances) and generally are from .008-.010 on intake valves ...

Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1

2 Answers

intake and exhaust valve settings i want the intake and the exhaust valve valve settings for this engine ? . it is a valve in block motor or what you may call a side valve motor You have not indicated

Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1

2 Answers

set valves on both sides of twin engine.mower wont start.take spark plug out on right side engine starts when setting gaps make you go toward the high end not low. if too low the valves will not close

...are other problems. Does the valve only leak when hot water is called for? Then check temperature setting on heater. Does it lek all the time? The water pressure is to high , Maximum Temperature ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plumbing Experts

Donni Steen

Level 3 Expert

687 Answers

Brad Brown

Level 3 Expert

18108 Answers

Tom Chichester

Level 3 Expert

54195 Answers

Are you a Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...