Questions & Answers for: pedal repair Vacuums

Wiring foot pedal switch legend II Foot pedal switch broke in my Legend II and I want to verify where and how the wires go back into the new pedal I purchased?? Also, do you know if the manual talks ...

kirby neutral/drive pedal I just re-installed the neutral/drive pedal (fell off) and now the vacuum drive rolls backwards HELLO, JUST USE THIS GUIDE! ...

pedal repair, and walk you through this step by step. The model that I did the repair on is a slightly newer model, but other then maybe the color of the vacuum, or the color of the foot release pedal

...pedal back), and lift straight up on the motor housing. You'll now have full access to the cord reel so that you may push the cord back through the hole in the rear of the vacuum cleaner. Please feel ...

...The drive unit must be removed from the machine, and the pedal assembly and shift cam can then be replaced. This may not be a do-it-yourself repair, as a good deal of disassembly is

...pedal was replaced about 6 months ago at the dealer. It hasn't locked into the upright position since the repair & I don't want to bring it to them again because it took them 10 ...

...missing that should hold the pedal in the up position, but I cannot see where it might be missing from. here is a video how to repair the pedal You-Tube video "r0ZaqymChXo" placeholder (do not

...the neutral pedal came off and the little metal switch on the inside came off and i can't put it back together will need to get Kirby engineer to repair, should cost 39 callout+28 for new ...

...repair drive pedal kirby drive pedal You will need to remove upper cover ,then remove the three screws holding the trans in. Slide out the old drive pedal reuse the cam arm and install new pedal. ...

...pedal, it's possible that there could be an issue with the motor or motor wires. To check this, you'll need to open up the vacuum and inspect the motor and wires for any visible damage or loose ...