...Magneto Coupler. (Located on right side of sled under the black 2" cooling line) 2. Connect meter. OHM x 1 White/Red - White/Green 189 - 231 OHM at 20 degree C (68 degrees F) Charge Coil Resistance ...
I cannot get a spark on the plug .Can you tell me how to dismantel the magneto for checking Hi there First you have to measure the resistence between the lead wire and iron core on the ignition coil .
...the charge coil resistance test should be between 270 - 330 ohms and the pulse(pickup) coil should test from 171 - 209 ohms, figures listed are for coils around room temperature of 20 degress ...
resistance figures and a multi-meter should lead you to the problem. CDI units, Reg/Rec, Magneto Coils and pulse coils are very expensive as are ignition coils. They will all be affected eventually if
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
resistance of the secondary winding (plug wire to ignition module frame) and compare the ones you have. They should all measure within a few hundred ohms. You offered no explanation on how you checked
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
no spark to spark plugs Could be any number of things from coil to magneto to CDI depending on what model you have. Consult the factory manual and tests the resistances of all ignition components with
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...resistance (using the Ohms setting on a multi meter) on the wires; and check to see if your ignition module is producing a strong spark...check the resistance on the primary & secondary coil. Or ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...ohms. You are going to measure for resistance across the wires on the magneto looking for shorts and opens. IF there are none then you need to check the gap between the magneto and the flywheel. IT ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...resistance with ohm meter from plug wire to cylinder head (not ignition module frame). Disconnect kill wire at the ignition module (magneto) to eliminate all possibilities of a short. It rarely is an ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...Resistance and voltage per manual The primary Ignition Coil Peak Voltage (static) should be 132 to 198 volts. I have 340 colts. I read online it could be the pulsar/trigger coil. I don’t know what ...
Usually answered in minutes!
263 Questions
242 Questions
114 Questions
93 Questions
72 Questions