Questions & Answers for: Toyota Corolla ohm spec ignition wires

looking for between 100 - 150 ohms to be within spec for this car. The ignition coils are what we used to call ignition wires or spark plug wires but now run without a distributor to be more efficient

...Ignition fuse blows.30Amp in engine bay. Checked for shorted wires, could not find. Disconnected alternator and starter, still blows fuse. disconnected distributor, still blows fuse. Checked starting ...

spec the top bolt.. Re-install everything you removed up top then down below Reinstall the battery(MAKE SURE THE IGNITION IS OFF!!!!!) Hook up battery... LOOK AT EVERYTHING...see if ANYTHING is loose.

were is the cam shaft senor and the crank shaft senor located this car does not have a camshaft sensor the distributor pick up coil acts as a cam sensor here is crank sensor info the crank sensor is ...

spec the top bolt, Reinstall everything You removed up top the below, Reinstall the battery and make sure the ignition is off while doing this, Hook up battery and ensure every thing that was loosened

...Thanks in advance check the alternator voltage output Your ignition may require resistance of a few ohms in series with the coil with the key in the run posistion. This resistance is bypassed when ...

...spec from or get reading with ohm meter and see if your has the same resistance good luck and let me know what you didn'tdidn't It could be the ignition module (igniter) and it could be a bad ...

wires leads back to the ECM (Electronic Control Module) Connector A (it is labeled). disconnect and perform same procedure using spray. Reconnect...you'll need to clear codes by disconnecting positive

...ignition coil pack in a 2003 toyota corrollla Usually, if you have good spark at all the spark plugs, then, I don't think the coil pack is your problem? If no spark, check primary voltage and ground ...

...spec is .043", for both the V6, and the Inline 4. The theory behind enlarging gaps, is that a larger gap creates a larger spark, thus more effecient ignition. The problem is, your ignition system was ...