20 Most Recent 1996 Toyota Corolla Questions & Answers

Hi Joe Yes, it is EGR Valve. Did you clear the code? https://www.google.com/search?q=1996+Toyota+Corolla+1.6++P0401 What about the IAC? https://www.google.com/search?q=1996+toyota+corolla+1.6+iac+valve What are the plugs like? It is something simple. ..

Hello Joe Clean the Throttle Body and MAF. Check for codes. Other ideas and videos here https://www.google.com/search?q=1996+Toyota+Corolla+1.6+stumbles+on+acceleration ,,

Yes Joe Just don't try and bypass it. You can keep cancelling the code. The ECM will try and work things out and compensate. If this was the vehicle that had the fuel system cleaner, it may right itself over a half tank with cleaner. The EGR is an EPA idea to make sure some of the unburned hydrocarbons (fuel) gets a second change at getting burned up. ..

Hi Joe Not likely to be those things. https://www.google.com/search?q=1996+Toyota+Corolla+1.6+engine+stalls+while+driving ..

i tried to decode this "and doesn't start it's not the fuel because I checked and even put in carb it should take when swinging (cranking) " I guess he meant sprayed test fuel to carb air horn, fails? the cam belt is bad,(slipped) and fully expected. and your adding fuel test is ON THE MARK, proves engine or spark dead.(mostly)

I would start with a tune up - plugs, wires, all filters & fluids changed. Make sure your tire pressures are up (check with a tire pressure gauge)

4 quarts of oil.

Could be a hundred things. A lot depends of what happened before. Get it on a good scan tool computer.

There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few like reliable-store .. let me know if u need help thanks

Remove fuse labelled "dome" on engine compartment fuse box. unfortunately this also isolates the radio. I have found when re connecting battery alarm goes off. remove "dome" fuse and then replace it. all ok then.

i m also facing the same problem..i have check all of them except the plugs, what r the plugs(part no.) for 7afe

try to clean your throttel body

check your dipstick and see if your oil is whitish if so cylinder head gasket is gone

you should be able to from the front part you may have to put a jack under the base pan and lower the engine down to access it good luck

probably clutch switch adjustment or failure

The ECU-B fuse supplies voltage directly to the computer (ECM), .041A is 41 milliamps and normal draw for the computer to keep it's memory.

Hi did you check the spark and spark leads Also any light on dash? after restarting does the problem clear or not? thanks

Manual transmission parts: - Manual transmission, 5-Speed. - ECM Engine Control, M/T. - Transmission oil SAE 75W85, 2.5 Litres. - Clutch pedal assembly. - Gear lever assembly, with console. - Gear lever cable set. - Gear lever boot. -

That is normal. When you put it in gear, the idle speed drops about 400 rpm.

indicates a fuel pressure or injector problem run the fault codes to identify the problem area