Questions & Answers for: Golden Technologies motor scooter

...scooter is fully charged but went from fully operational to just clicking and not moving at all. Can you help? Hi. I have had this problem on many machines. It is normally a stuck brush in the motor. ...

...scooter m Can the moter that goes into the axle shaft be replaced? Hi. Why do you need to replace the motor? Very few motors completely burn out. Most suffer from stuck or worn brushes, and these can ...

...of the free wheel lever, ususally it is near the rear of the scooter. If the chair is in DRIVE mode but the wheels will not turn, you may have a motor problem which would require replacing the

scooter will not movw. getting power to motor Make sure the brakes are released, motors are engaged and not in the freewheel position. Good luck!

scooter to take a turn. The motor is connected to the trans-axle with a plastic coupling. The noise you are describing is from several possible sources. Take off the seat and rear cover . Block up the

scooter for your safety until the motor can be replaced; contact the manufacturer for a service call to fully diagnose the problem and give you a quote. If your insurance purchased the scooter for you

...8 Flashes ? Indicates a motor voltage problem. ? Your scooter will not operate until the problem is corrected. Remedy: Contact your authorized Golden Technologies, Inc. dealer. Hope this

motor and its power supply. Block up the scooter so the drive wheels are off the ground. Now apply power until the wheel just starts to move..Does the motor stop at some point, does the meter suddenly

scooter relates to a motor voltage fault. This means that the correct voltage is not getting to the motor from the power supply. This can either be caused by a bad harness between the power module and

...SCOOTER HAS NO POWER TO MOTOR UP EVEN VERY SLIGHT GRADES OR HILLS GOES REASONABLY WELL IN FLAT AREA, BUT VERY WEAK ON GRASS OR WITH ANY SLIGHT INCLINES. If batteries are ok. I would check motor ...