...valve or injector i need to know where the cold start valve or injector is on a 1990 ford ranger 2.9L injected there is an idle control valve on the intake plenum right by the throttle body air ...
What is the torque spec for the intake manafoild? they have no torque spec but if you use a socket wrench with a 6"handle,as tight as you can do it up is tight enough...
...issue. No check engine light, no codes. Replaced IACV, intake manifold and plenum gaskets. sounds like the accelerator is sticking might wanna spray it under the hood with some kind of ...
...intake plenum (the top aluminum housing, very top of the motor) and about centered on the plenum.in 1994 I have seen Rangers with and without a egr valve. I believe it depends on if its California ...
What is the intake plenum torque spec & sequence for 2006 ford 2.3L Here you go!!
...Intake Manifold Runner Control Stuck Open.You might want to look at the IMRC valve. It is probably sticking from carbon build up? Use top engine cleaner and clean the air plenum.Once you have ...
Question about 1998 Ranger SuperCab
torque specs on intake plenum and fuel rail on a 98 ford Ranger with a 4.0l Hi the torque spec for this fuel rail/manifold is 9-11lb/ft. Here is pic of the sequence.
how to replace a valve cover gasket on my 1987 ford ranger You will have to remove the top half of the Air Intake Plenum and then you will have no problem.
Intake plenum bolt torque spec for 206 Ford Ranger 3.0 liter V6 86 inch pounds. About 7 foot pounds.
Question about 2006 Ranger
...plenum and found gooey black in forward intake ports. No sign of lost oil. that will be oil vapor from the sump have a wet and dry compression done to determine engine condition use plugs with a ...
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions