20 Most Recent 1989 Ford Ranger Questions & Answers

there is a bleeder screw by the transmission slave cylinder that you bleed the air out.just pump the clutch pedal a few times hold the pedal to the floor and have someone crack open the bleeder screw to bleed the air out then close it and repeat.make sure the master cylinder for the clutch doesn`t go low.

Anything from a bad cable adjustment-cable to a bad transmission. Make sure the fluid level is correct.

I suggest you get one of those manuals people get nowadays to do it yourself.. Also My nephew use it to repair my car and it's totally repaired now. Here's the website he bought it from. Best Manuals

Depending on your vehicle make, you may need to be in D2 or D3 (or reverse) prior to your automatic 4 wheel or all wheel drive kicking in.

Are you sure you have the correct voltage battery or have you got the terminals the right way as it sounds like you have cross wired it or put too much power through it.

Clean all connections and check for a corroded cable

run the fault codes and check for an EVAP venting problem could be the valve or the solenoid to control the valve indicates that the fuel pump is having trouble pulling fuel against th vacuum in the tank from a vent problem

Probably stopped up cat

If you look down in the top of the transmission where the shifter goes. You will see three parts. These parts are forks. There is a center slot in all three. The slots have to be lined up and in the center. This is neutral. Then the shifter can be installed.

Alternator or starter

A locksmith may be able to help in this situation and supply a key

Not enough info. what is wrong with the truck? Why do you thinka certain wire on the ECM needs attention? What fault codes does it have? Did you check ALL fuses? What ENgine? Trans? Options?

El sensor esta en la parte frontal superior del motor, a un lado de la manguera que conecta al termostato, tiene dos entradas de espada, remueva el conector, remueva el sensor e instale el nuevo, asegurese que las conexiones esten bien sujetas al nuevo sensor.
Saludos.

Do you mean you have an airlock ....try purging the cooling system if that is the case

sometimes the diagram is located on / in the lid