6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: 84 inch/lb (7) Ft/Lbs (To torque bolts, start in center using crisscross pattern
...intake plenum has to be removed. How difficult is this task. Is it something that one can do easilily or should I take it to a repair shop. Depends on how MECHANICALLY INCLINED you are. Have you done ...
Need torque sequence and torque specs for intake plenum on 3.5L 02 Olds Intrigue. bottom intake bolts torque 15-18 ft lbs from center and in criss cross pattern top plenum bolts 12-14 ft lbs
Question about 2001 Bonneville
...intake plenum and gasket Thermostat housing Electrical connector from the Engine Coolant Temperature (ECT) sensor Drive belt tensioner assembly EGR valve outlet pipe Lower intake manifold Fig. ...
...Intake Plenum Gasket R+R Torque Sequence Just need torque sequence/settings for upper intake plenum gasket R+R? I cannot post a picture here because that is copyrighted material. However, the ...
in need the torque for the bolts to the plenum the bolts that go into the plenum to the lower intake theres 7 bolts and they need to be torqued intake manifold upper and lower 89 in. lbs.
2002 nissan xterra intake torque 3.3 intake plenum torque Here's a link to your intake. Repair Guides Engine Mechanical Components Intake Manifold AutoZone com
Question about 1991 Accord
is there a torque spec for the plenum nuts going on the intake manifold studs? on 1991 honda accord 2.2 l there is a gasket in between plenum and intake manifold. 14 in/lb
Question about 2003 Intrepid
...Intake Plenum: When installing the intake air plenum , be sure to catch the four center bolts and the two side bolts (stiffener brackets) before tightening , The center bolts should be torqued to 250 ...
Usually answered in minutes!
Step 2: Please assign your manual to a product: