...pinion/brush reaquaintment. Did this to our Bissel Velocity Widepath. Had same problem. Great performance after belt dressing was applied. If that sounds too dangerous for ya, get a new belt and ...
...not sure what it was doing in the fan chamber but anyways - go HERE and you will see how it is installed (picture next to step #10). Makes sure you use 2 gears of the same color. If you need a ...
...down or is broken.take it into kirby and they can fix it for you. A gear set and drive belt are not that expensive and easy to install. You can find them here ...
Question about S318 Bagged Canister Vacuum
...install the new pinion gear, just use the screw driver the same to tighten the pinion gear onto the motor shaft. Please feel free to request a clarification to this repair if you have any further ...
into may have gotten stripped as well. You might try to operate the vacuum without the roller brush installed for a few seconds just to see if the gear turns. When I say gear, it is actually a somall
Question about Ultimate G Bagged Upright Vacuum
...gear on the end of the armature shaft. The pedal assembly can be removed by removing the remaining screw from the bottom of the drive unit. The N/D pedal has two parts - the pedal itself, and the ...
...gear on the end of the armature shaft. The pedal assembly can be removed by removing the remaining screw from the bottom of the drive unit. The N/D pedal has two parts - the pedal itself, and the ...
...gear on the end of the armature shaft. The pedal assembly can be removed by removing the remaining screw from the bottom of the drive unit. The N/D pedal has two parts - the pedal itself, and the ...
Question about Ultimate G Bagged Upright Vacuum
...gear on the end of the armature shaft. The pedal assembly can be removed by removing the remaining screw from the bottom of the drive unit. The N/D pedal has two parts - the pedal itself, and the ...
Actuator arm Installation The brushes quit spinning and when I took apart the turbine assembly the gears were stripped. I ordered a new assembly and when I went to install the actuator arm fell off ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions