...stuck... James Saniya: Meanwhile, try the below steps Saniya: Select Start > Control Panel > Hardware and Sound > Tablet PC Settings > General tab. Click Calibrate . Follow the instructions on the ...
...stuck there? wont boot from rom drive disk either hmmm..now..that's not too good..perhaps you need to reformat that drive? or you may find that motherboard is not seeing either item? got a backup on ...
...CD and install this on your newly created partition. And tell me if you got stuck any where or hav any problem. Thanks Iqbal that engineer sounds like a right ***** !!! you can reset ur bios to ...
cd if your wondering. Once I got home, i opened the laptop and blow dried all the inside then left it open all night to dry till today afternoon when i decided to take it to the lousy techs. They said
...CD/DVDwriting softwares are saying the same thing. Cannot write to calibration area. What does that mean? In my case it means that my DVD/CDwriter in this laptop is defective and never was very good ...
stuck. I started the process by going in BIOS setup (f10)then did something and changed it to default boot and CMOS i guess. restarted and windows loaded. Remember i had the recovery dvd in the rom. i
Question about PAVILION A6230N DESKTOP PC
...cd too i have not pulled all back in just in install new mother board same thing stuck no key board 1 blink/ f10 got setup ..... stuck . This may be a chip set driver not installed. or a bad hardware ...
...stuck in this situation before, but usually for a customers computer. Its actually quite simple after you do it the first time sucessfully. #1 Download this file(Don't worry, I scanned for viruses, ...
...cd so long as you set the boot options up correction in the bios. Let me know if you get stuck. If you are using Windows XP, the computer Bios will recognise the hard drive (does it do this in the ...
Usually answered in minutes!
5,069 Questions
2,066 Questions
1,195 Questions
1,096 Questions
608 Questions