tell me which front panel connections go on which plug on the front panel plugs on the iwill xp33-r motherboard. Cheers Derek PWR > PWR (aka PWR SW), HDD LED > HDD LED, RST > RST (aka RST SW and Reset
...pwr, another is led and the other hdd.Could you help clarify,thanks Steve pwr (power) goes to the on/off switch (led) goes to the light (light emitting diode) hdd goes to the harddrive (hard drive ...
Question about eMachines Desktop PC
...pwr led,hdd led speaker connections on the motherboard. Model p5s 800-vm. the connections for the pwr ,reset,speaker, hdd led, pwr led. I cannot read the info on the motherboard Hi there. On the ...
...pwr sw - 8 hdd led+ 10 hdd led- 12 n/c 14 n/c (gnd) 16 n/c 18 n/c 20 n/c (+5v) n/c = no connection Difficult as in their manual they have already been connected but try connecting as in picture .Good ...
...2 missing. 1 2 reset+ O X key reset- O (gnd) O pwr sw + pwr led+ O O pwr sw - pwr led- O (gnd) O hdd led+ -- O O hdd led- | O O -- | O (gnd) (gnd) O | n/c -| O O |- n/c | O O | -- O (+5v) O -- 19 ...
...goes where. ie pwr I need to know what connector goes where. ie pwr led hdd led pwr switch http://www.starlino.com/data/remote_pc_switch/images/front_panel_connector.gif Try that ...i hope it helps ...
hdd/led pwr/sw pwr/led? on an AMD Motherboard n1996 Cklick on this picture and you will know...You have to connect all three to "Front Panel" connector the way it shows on this picture... http://img33
Question about T3958 (827103050974) PC Desktop
...HDD LED PWR S/W and PWR LED for board unpluged HDD LED PWR S/W and PWR LED from board need to know what pin to hook back up to E mechine it's usually written in fine print beside pins. Failing that ...
...HDD, PWR, RES or RE the pins are marked. Now on the wires to the power button you will see the same wire abbreviations. Just hook up the HDD wire to the HDD pin the PWR to the PWR button wire and so ...
Question about Dimension 2400 PC Desktop
...HDD-, usually white or black 2= PWR LED+, usually red 4= PWR LED-, white or black These are polarity specific, and must be connected to the proper + and - terminals to work properly 5= RESET 7= RESET ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions