...What else can I check? Ensure that the front caster can spin freely, pivot, and rotate. Remove the caster by pulling it out and clear any dirt. Reinsert the wheel and lightly push the wheel up and ...
Question about Roomba 560 Robotic Vacuum
...wheel drop sensor instead of a cliff sensor. Clean the caster, caster axle, caster motion sensor, remove and vacuum or blow the dirt from the left and right wheel assemblies. Very common error. The ...
...clean the 4 cliff sensors, the bump switch, the caster, caster axle, caster roattion sensor, and remove and vacuum or blow the dirt out of the left and right wheel assemblies to resovle the
...and the 4 cliff sensors along the bottom of the front. Make sure the front caster wheel turns freely. You may have to remove the roller from the caster assemply and push the axle out and clean
...is to do as it says and remove the base plate and the wheels and clean them. Don't neglect the caster in the front when you clean the two drive
Question about BSG71360UC Bagged Canister Vacuum
wheel (caster) for a Bosch BSG71360UC vacuum. Can you tell me where I can get one? Hi There, The casters for your Bosch are unfortunately sold as an entire assembly with all 3 wheels included when you
...Wheel Caster (Set of 4 6774200 casters with retainers) Catalog No. 420-63-96 Four (4) casters. Set of 4 Replacement Caster Wheels with retainers. This item is the replacement for the plastic, ...
...each casters. And work condition for example. Bigger wheel easy to push,And soft floor better us hard wheels,Soft wheel can protect floor ...... Caster Wheels PU Caster Polyurethane Wheel Nylon ...
Question about 925-13 Canister Wet/Dry Vacuum
...this link below ...
Question about 925-13 Canister Wet/Dry Vacuum
...wheel assembly off. The manufacturing engineers were of the opinion that this part would not break so I think when they designed the part they did not have in mind that someone may replace it. This ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions