Questions & Answers for: Mercury Cougar break switch

...will also be retaining clips attached and you don't want to break them. You will then be able to access the harness attached to the switch. Disconnect and replace with a new switch and then ...

...switch that the break pedal arm presses in when you push the pedal. this switch can either be bad or it could be out of adjustment and something near by has moved and it is in a bind to where the ...

...switch on interior lights, if not may want to wd40 switches that the doors engage when shut. These are small usually push button types, they do break too and are adjustable check your switches than ...

break isnt on. 99 mercury cougar Your brake switch is probably stuck. It is located under the dash in the cab, above the pedals. It is a chrome looking cylinder. It has a button on the end of it, when

...BREAK PEDAL IT HAS A SWITH BUTTON THAT WHEN YOU PUSH THE PEDAL TO BRAKE IT MAKES THAT THAT BRAKE LIGHTS TURN ON AND WHEN YOU RELEASE THE PEDAL TURN THE BRAKE LIGHTS OF THESE SWITCH HAS 2 CABLES YOU ...

break is pressed. Checked fused and bulbs. Also filled the tank tonight and "CO" displayed for about a mile then went away. Manual simply says there is a problem...take it in. Well I can'

break lights keep messing up also my sifter will not move out of park both related to same problem. replace brake switch..

...is a safety switch on the brake pedal lever which gives a signal to a safety lock-out. Check your brake lights. Often the drivers feet hit this switch and either break it or move it out of

switch turns on the brake lights Like William suggested, it's connected to the break peddle. Look for an actuator at the top of the arm. I have had the wire come loose from the electoral box connector

...switch, repair the wire, they usually break close to the plug. This will get back the lights and shifter. The no start would be the neutral safety switch on the transmission. Usually the switch is ...