It has ink and it has no problem lights on but it wont print anything

The black ink nozzle in the print head might be blocked. Print a test page with a huge black image. Like: just start word, create a square through "illustrations" and fill it completely with black. Print it once or twice and see if finally the black ink may come out.

Through printer properties (windows control panel) there might be additional cleaning options.

have you tried printing a test page?

You probably need to remove the protective film from the contacts on the cartridge. murf427

All the ink cartridges need to have ink in them to allow you to print, even if you only want to print in black only.

Start by uninstalling the printer software... then re-install the newest software from the HP website. Always works for me...

erase all the pending documents on the printer and replace new printer cable or usb cable

It will print with no ink it will just be patchy.
It is also best to not let them run out of ink as they dry up in the print nozzle a pain to get working again and uses a lot of ink as you need to do several head cleans.
You may need to turn it of at the power point then after 3 minutes turn it back on again.
Also reboot your computer it may have not have started properly.
This should reset it.

My printer will not print after I put in a new cartidges it is a Canon
iP1700.

if the red light is still flashing then try and reseat both the ink cartridges and print head and make sure you use genuine kodak ink cartridges as there are retailers selling look alike and refilled ink cartridges.......if still the same problem then print head problem call kodak tech support they will replace it for you without any charge........

need to replace all to! some printers are like that wont print unless all inks are full and inplace!