I was given a Jamo sub 1810, but have no instruction manual. I'm trying to hook up to my Pioneer HTP-2500 home theater system. What would be the correct way? Also if you could help me with the setup, that would be great. Thank you for any help.

The reset procedure will be in the owner's manual. If you no longer have the manual, look to the Pioneer website. They will have it if it's not too old. Should you have further questions, please visit my website at audioserviceclinic.com. You may contact me directly through my website. Thank you.

just buy a adaptor like a normal plug socket that your 2 pin 110 volt can plug into it then plug it in to the 3 pin 240 volt socket an bobs your uncle your sorted.

Check out this link:


http://2getdtv.com/directv/stereo_receiver_codes.html?phpMyAdmin=ed9585cdc5a4551847999cb4dbcce76a

Active or passive subs (size is irrelevant)? Do you have the manual(s)? It might talk about that. If active subs, get an RCA splitter cable and share the subwoofer output.

I can't find that message in the manual but I would guess it's trying to tell you something is wrong going out to the subwoofer. Trace the wiring. If you don't see anything wrong, disconnect the sub and see if the message disappears or changes.

I'm referencing a VSX-1016 manual, so I hope it's close enough to help you find the function...

Somewhere in the System Setup menu you'll find a setting for SUB W. The wrong setting is NO.

Set it to YES or PLUS depending on if you want ONLY the Sub to carry all the bass, or if the Front Speakers will share bass with the Sub, respectively.

one will do just fine if you've tried one and its not working try to refer to manual on how to set up in the receiver function menus and if the sub is powered by an external amp which most are

i just installed my htp 100 sw. the scheme was atached to the back of the woofer for me tho. easy. front speakers go into the sub in the two botom inputs from the receiver. the two upper are outputs to the actual speakers. hope it helps

I suppose that your system requires an active subwoofer, and that you provide one. Some systems, if SPEAKER SIZE in SETUP are set to LARGE for front or center speakers, do not send signal to sub, system redirect signal to front or center speaker. Try to check this.

There is a problem with the volume controller chip, or a problem in the paoer supply feeding the main amp. Good Luck