Error message E20 - Frigidaire ATF6000ES Front Load Washer

Error code E20 in Canon NP 6241 copier

If it's only 4 months old it should still be under warranty. Contact the place you bought it from and explain your problem to them. They should repair it at no cost.

maybe you should just get a new washing machine

go to www.fitness.manualsonline.com or www. retrevo.com and download your instr.manual for to clear the errors .

God bless you

Hi

Error code e20 means a clogged drain pump. This might have happened due to small clips, pins, coins, etc being stuck in the pump. Please note that error e20 can also occur when the drain pump is not pumping fast enough or when the pump fails. To fix the issue you'll need to check the drain pump. Tilt the machine on its side and remove the 3 screws and 2 wires that hold the pump in place. Hope this helps... Please post back for any further assistance.

Daniel

E20 is not an exact error code. It's indicating a possible pump out problem. Here is a few possible causes of an E20 error code:

1. Restriction in the drain pump

2. Failed pump

3. Water not pumping out fast enough (crimped drain hose)

4. Too many suds ( too much detergent or wrong kind)

5. Pressure switch (not communicating with control board)

6. Loose wire at pressure switch

7. Loose wire at pump or control board

8. Failed control board

This means that in the save path there are some not supported symbols. Try saving in c:\ or d:\. This helped me.

If the CD is over 60 minutes it will not play on domestic cars

It's just an error message. It stands for Error 20. There is no way to fix the problem. It only reads cd's that it wants. But if it does play a cd, then suddenly stops, and says E20 and spits the cd out, it's most likely because the cd player got too hot. My car does that all the time. And it won't play a lot of burned cd's. Hope this helped.

Hi Helenw,
The error message E20, simply means the filter plastic cage which is located behind the trap door bottom right side of the machine is full and needs to be cleaned out.
All the fibres and lint gets trapped in here and prevents the waste water from escaping, hence Error code E20.

Regards,
David