Re: The screen shows a picture that resembles a film...
The TV's convergence is out of alignment, because the colors are out of focus, thus the colorless picture. Try replacing the STK convergence chips. Check online for the correct STK chips for your Sony model.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The Nikon F3 uses standard 35mm film, also known as 135. The type of film you use is up to you. You can use black&white film, color transparency (color slides), or color negative (color prints). Prints are generally cheaper than slides but slide films generally produce better results, and prints can be made from slides. You can also make black&white pictures from color films, though obviously you can't go the other way. These films are available in a variety of speeds. Faster films let you shoot in lower light and/or with a faster shutter speed for stopping action, but slower films have finer grain. Different films also have different color properties. No film (or digital sensor, for that matter) reproduces every color exactly. You may need to experiment in order to see which film gives you the colors you like for the types of pictures you like to take.
The tv have a problems known as a convergence problems,it dead.Tv have colors lines R,G,B mis alignments,have colors shadows pictures or 3D pictures look alike?The tv convergence board have dead 2 STK convergence ICS and some or all it resistors too.By replacing all these parts on the tv convergence board to fixed it to solved the tv pictures convergence problems.The shop,will cost u like $300-350 for parts and labors.
The colors wheel could dies at any time of the tv life,at any monent without any period of times.The colors wheel run at RPM spinning revolution are 1000 RPM a min. to make colors for this tv.The problems u discribing are one problem of the effect of the colors wheel is dying and worn out.The colors flashes like film negative,the picture flashes Black&White withtin the picture.Replace the colors wheel again,will solved this problems.
You may have not reset the lamp counter after replacing the physical lamp. To do this 1. Press the “POWER” button so that the projector projects the picture on the wall (projection screen) 2. Press the “MENU” button to show the “MAIN MENU” Use buttons “F” or “G” and select “OPTION” 3. Confirm this by pressing “ENTER” so that “OPTION” is shown Using buttons “5 / 6”, select “LAMP RUNTIME” (lamp operation counter) 4. Select and press the “ENTER” button for at least 3 seconds 5. The “LAMP RUNTIME” (lamp operation counter) will change to “TIME RESET[POWER OFF]” 6. Turn the device off by pressing “POWER” and unplug the power cord
You have bad solder connection in or around the Jungle IC and or color processing Circuits. Most commonly the area is the color cyrstal, located on the main board.
×