Mah5500B. during spinout a "nd" error message shows up where time is usually shown

ND error code means no drain check the pump filter check the pump and check the drain line that goes from the oulet port coming out of the outter tub to the pump and also check the drain hose leaving the pump that goes out of your washer as well. If you have any further questions message me back I await your rely
Thank you,
Rick

nd (no drain) so its probably aproblem with the punp/or a blockage

Hello,"nd" refers to a No Drain issue . check for restriction in pump assy, restricted drain hose loose wire at pump, bad pump.
Thanks

The washer experienced difficulty draining. Check for a kinked drain hose. Check for a plugged stand pipe.

well nd means no drain
but you may not have a p[roblem
quite a few times during this repair, the plug for the pump got pulled out, but if thats not the case
just disconnect the pump and make sure there is nothing in it these lil pumps are actually pretty hardy
so im pretty sure its one of those issues

nd=-no drain
remove the back panal you will see the pump
its probably just clogged

There should be an error code star with E-01 to E-06.Below is an example you have to make sure that which error code showing on your camera
Whenever some abnormal signal is input to the syscon CPU,
an error number (E01, as an example) is displayed on the
LCD monitor or (in the electronic view finder).
In every error status, such the message as shown below
E01 LOADING--------
1. The mechanism is locked during mode shift.
2. The mechanism is locked at the mechanism loading
end, because the encoder position is skipped during
mechanism mode shift.
3. No power is supplied to the loading MDA

ND - No Drain
Machine control board monitors water level in washer during and at the end of pump out. If wash level does not reset pressure switch, it will see water left in the washer.

1.Check for pump/drain restriction.

2.Check pump operation.

3.Check pressure switch for open contacts.

4.Check inputs and outputs at machine control board.

5.Replace responsible component.

ND error means no drain. When this happens it is usually a problem with the drain pump assembly, located under the bottom panel, inside the machine.

check the drain hose and the drain lines, ensure they are not obstructed. Probably the drain pump need replacement.

nd= no drain. loud buzzing noise sounds like something stuck in pump assy.remove the door(2screws) adn other 2 screws oppisite side, and hte front panel comes off giving you acess to the drain pump, pull the hoses and look for the obstruction