Hi i have a hotpoint washin machine and it kepp showing H20 on the csreen can you please help th model number is WT740

Google your question


How to fit and change Hotpoint Washine Machine Bearings

Machine start normally but after some time it display H20 and stop. When i switch off the power it restart but again after few minutes it is same. Kindly help.

Hi from retired Englishman in SW France,
Indesit (Hotpoint, Ariston) Error code H20
(Quote)'If the machine is not in the demo mode and this error is displayed it means there is no water being supplied to the machine.
To cancel press and hold start/cancel then press again to cancel the drain and the machine should now be reset and display 'ON' as usual.'(unquote)

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

hotpoint washing machine WT740 1400 code erroe F-08 flashing machine stops working after 20 minutes please help

Hi there,

Well error H20 does indicate no fill. 
Make sure that that there is an adequate supply pressure to washer, check that there are no kinks or restrictions in hose. To be certain if you have an adequate supply turn off water valve to washer, disconnect hose and hold the hose into the sink or a bucket, turn the water back on, and see what the pressure is like..
If ti is too low, then the valve will not operate properly.
If you think it is ok then it is quite likely a valve fault, also check the filter built into the valve inlet.
Please post comments if further you have the same problem or you need more help or information........

Good Luck!!

Thanks

h20 code indicates that the appliance is not filling at all or filling to slow,check pipes are not kinked and taps are open correctly

Hello bennff,
Welcome,

2.5 years old from manufactures date or bought used???

Is this the correct model number found , ON THE WASHER?
WT740

It is not showing up in my repair search.
Where did you buy this washer?

hi you can download a manual (free) from hotpoint it will tell tuo in there.

h20 fault code means you have a water supply problem.
check you have suficiant water pressure coming into your appliance,and also check that you have no blockages at the sump of the apliance and if plunbed to the sink check for blockages there.
f08 code means that the heater relay is stuck or open curcuit,check connections on your module and check your heater is not open curcuit,if these are ok you will require a module.

Click on your model numbers (below FIXYA) on this website, & search. You will get a shortlist; click on your model,below the page u will get Manual/Guides. Click on the blue, you have your manual on line. You might find the mysterious codes there.
And dont forget to rate me on this great site.