I'am looking for codes for my scanner. - Radio Shack Pro-2018 Scanner

If it is a c-3200 code it means that you have a exposure lamp problem.Defective scanner,defective scanner PCB,lamp or inverter board,incorrect shading,poor contact of the connector terminals on lamp assembly. Look for a bad connection And look at lamp. Look for blue rings or burnt ends. Now don't look at that light while its on.

If by codes, you mean frequencies, go to http://www.radioreference.com/apps/db/
and choose your state. I think you might be able to find what you are looking for.

The only way those type of scanners will give you a code is if it is a hard code. When a check engine light is on, but doen's flash it is usually referring to an emission problem. A flashing light refers to misfire. Spark plugs, wire, etc. A snap on scanner or Genesis Scanner is able to look at perimeters inside the system which is a better approach when you don't have a hard code. Sometimes after the code is on long enough it will become a hard code and the type of scanner that you have will pull it. The thing that often happens is the EGR isn't circulating properly and you get an intermediate light and don't get a hard code for a while which leaves you in the dark. You might take your vehicle to a local service shop which uses a better scanner and they can look at what is going on and solve that problem.

you need to have the code read to see what it is most auto parts store can do that for free that will help use tell you what it is

Code 93 is not enabled on default. Scan the Enable Code 93 barcode from Adobe page 190 of 342 from the LS2208 Product Reference Guide. You didn't say which scanner you have but most Motorola scanners use the same barcodes. If the scanner does not accept this barcode then look up the PRG for your scanner and find the barcode in that manual. You may also need to scan the Code 93 Any Length barcode from the next page if your barcode is less than four characters.

Here is a site you can try that has frequencies for Clinton County. http://www.radioreference.com/apps/db/?ctid=1834

hit manua enter number then Ebthat should put them in again

phatgirlz, hi, are you looking for freq numbers for your area of Illinois? If so, go here, and click on your county.
http://www.radioreference.com/apps/db/?stid=17

If your looking for 10 codes and other police lingo, go here;
http://www.bearcat1.com/radioil.htm

Hope this helps you out in your search,, let us know. Mechanic

Lil p, hi, I'll see if I can solve your problem. If you are looking for freq's for around your area, go here and click on your country-state-county and it'll give you a complete rundown.
http://www.radioreference.com/apps/db/

If you do need a 10 code list for your area, go here,and click on your state.
http://www.nat-com.org/radio.htm

I hope this helps you out with what you were looking for, let us know.. Mechanic

Just find your state here...

http://www.radioreference.com/modules.php?name=RR

and search Google for Scanner frequencies + your state and you will find a lot of links.