NEC LT265 projector keep blinking status led light. Hope can get a services manual to fix it. urgent jazz

Could be a bad power supply, or lose connection try another one

probably needs filters cleaning or a new lamp replacement.

Below is the manual. go to troubleshooting on pg 56 and you can find out what the flashing LED means. Good Luck!

http://www.support.nec-display.com/dl_service/data/manual/english/vt670_manual_e.pdf

Select the Menu [Reset] → [Clear Lamp Hour Meter] to clear the Remaining Lamp Time and the Lamp Hour Meter

http://www.retrevo.com/support/NEC-LT35-Projectors-manual/id/357ci857/t/2/
User manual above, use troubleshooting, procedure.
neurowww.cwru.edu/_media/.../projector_manual_3062.pdf?id...
service manual above.

It cannot be a ballast because the fan would not run off a ballast. Sounds like a serious hardware failure, I would check with the manufacturer.

I had this same issue and it was the bulb. We had 2 of the NEC LT265 projectors so we swapped the bulbs between the 2 and it tracked with the bulb.

Replace the bulb.

If it is a lamp error try this:
When the lamp exceeds 2100 hoursof service, the projector cannot turn on and the manu is not displayed. Do the following:
For VT670/VT470 Press the help button on the remote control for a minimum of ten seconds.
For VT570/VT47 Press and hold the power and the exit buttons on the remote control simultaneously for a minimum of ten seconds. When the lamp time clock is reset to zero, the lamp indicator goes out. Hope this helps! :]

There are different rates at which the status light will blink to indicate various errors. See manual (link below) page 49 http://www.support.nec-display.com/dl_service/data/user_manual/ENGLISH/VT37/vt37_manual_e.pdf