My Everstar MPM-08CR-BB4 air conditioner is blowing cold then hot air. How do i fix it? It Blows cold air for a little while then it blows Hot air, if you mess with the controls it blows cold again for a bit. It does not dehumidify like it should...I left it on all day and it only got about 1 cup of water in the bucket.
Check your thermostat or battery backup or both..change or replace if necessary..
SOURCE: My Everstar mpm-08cr-bb4 stopped working and dislays P1
The P1 code means the lower water bowl is full.
Put a pan under it an pull the lower plug (some 10" below the upper drain plug that I hope you have a hose attached to.
SOURCE: My Everstar mpm-08cr-bb4 stopped working and dislays P1
Make sure the water container is clicked in properly. I found this to display the P1 and flashing red light if the floater switch is not properly engaged.
487 views
Usually answered in minutes!
×