Whirlpool ADG 6556 flashing code

Please recheck how many times it is flashing. It can be as many times as 13 flashes to be an error message. Try this webpage as a guide to what it could be.

https://www.espares.co.uk/advice/careandmaintenance/whirlpool-dishwasher-error-fault-codes

turbid water!

Whirlpool Dishwasher Error/Fault Codes - eSpares

https://www.espares.co.uk > Advice Centre > Dishwashers
FA (or 11 flashes) - Optical water indicator (turbidity) ... This fault indicates an error with the sensor in your machine that monitors the water cleanliness. If ...

Whirlpool Dishwasher Error Codes - Lights Blinking Flashing

https://removeandreplace.com > ... > Dishwasher Repair
Mar 9, 2016 - Some Whirlpool dishwashers display an error code by flashing the clean Light on the display in a pattern.

Whirlpool ADG 7560/2 pumps in water, then beeps with error ...

https://www.reddit.com > Whirlpool > comments > dish...
3 days ago - Dishwasher - Whirlpool ADG 7560/2 pumps in water, then beeps with error and 11 flashes. My dishwasher started faulting.

..

reset the panel by hitting normal-- heat dry NOT at the same time until all lights flash then push cancel and it should start. element is going bad

Hi, here is the answer for f2 "F2 - error code means "Shorted keypad".
Remove power from the range, open the control panel and unplug the membrane switch ribbon from the control board.
Reconnect power to the range and observe for an hour.
If the error code reappear - replace the control board.
If not - replace the membrane switch.

Brynn_parson:
Thank you for your review.
We would like to inquire further about your review with you. Please respond back to this email address, [email protected], with your name, phone number, street address, zip code, model & serial number, and date of purchase on the appliance.
We look forward to your reply.
Thank you,
Whirlpool® Social Media Relations

If this model has the normal wash, and heated dry buttons there is a sequence of buttons to press to do the reset, which buttons do you have, reading from left, to right on the touch panel.

the eprom memory is brocken,the main board must be changed.

Mine was doing exactly the same. I turned off power, held down the 2 black buttons on right, switched back on and the start button flashes intermittently. It then allowed me to change programs, just testing it now!! It started, this was more then it was doing!! lol

Raise your water supply temerature. Next open door and within 3 seconds hit hi-temp scrub, then energy saver. Do this again. Close door and latch, then push reset button.