Where in can chek the oil for the transmision on c320 2001

hello, before change a lot of parts of your transmision, you should chek well... i guess that you are having some problems with the stabilizer, this one is taking all of the weigt transfered to the front or from the front side on accelerating or decelerating cycles; but allwais... should chek well if it exist a problem with the part that we are thinking to change. good luck!

yes you can change it. but you will need a suction gun

For 2004 BMW 745i, (E65 & E66 type), the oil capacity of automatic Gearbox Transmision, (GA6 HP26Z type), is 9.0 litres.
Oil type: Automatic Transmission Fluid (ATF) Shell M1375.4

Please rate my response. Thanks!

chek oil of transmision

Check transmision oil level, Place car in park, hand break, open motor compartment and check transmision oil level with motor on idle. Good level?: transmision is bad, repare or replace the whole unit. bad level: complete and check for leakeges.

next to axle on pasanger seide is chek nut,yu haw to raise car meke shore is safe and lewel,lose nut if fluid coms to leak is full ,if naed fluid open red cap on top of transmision and ad fluid untl start caming from hole,put in nut,yu dane lewel is ok,if transmision dont laek yu dont hawe to chek lewel,remember replece treni fluid ewry 30k.go somwer and make transmision flash.Thenk's

likely the fill tube is where you check the fluid if it's larger than the oil check tube

Hi the answer is yes ,,the oil in the cooler is the same in the transmision in automatic vehicles,if you miss any oil the transmision will not shift do to lost of oil pressure, and it can couse severe damage to the transmision... good luck

Transmission fluid goes in through the dipstick tube. You'll need a funnel, possibly a long flexible one, to avoid making a mess.

there is an oil seal between the transfer case and trasnmission housing, if your bearings have gotten hot in the transfer case, this could have caused the oil to heat up and damage the mechanical seal