Just need to reset the time on the main console norstar startalk 180 - manual doesnt have set up instructions

Before you can do anything you need a M7310. Programming a Nortel voice mail requires M7310. It uses the 3 soft keys under the display to program it. You can get one cheap on EBAY. Next you need to find out what type of Voice Mail System in connected to your Nortel phone system. Below is a link to a Older StarTalk manual. You may have a StarTalk, StarTalk Flash, or a Call Pilot.
http://www.myuserguides.com/Nortel_Norstar_Startalk.pdf#page=15&zoom=auto,-69,407

Below is a link that tells how to reset the System Manager Password.
Reset Admin Password Norstar Meridian and Nortel BCM Help Guides

The default code and password for System Admin is F983 and 1020000 or 1021111. The photo below shows a system admin programming tree. Hope this helps
Charlie

To set the time on the startalk 180: enter feature 984
the display should say log:
enter 1020000 and press ok
display should say <date>
press next if ok or chng if not
display should say enter hhmm:
enter time in 12 hour format
display should say retry am pm
press applicable key
press next then Rls

to reset the administrator pasword enter feature 985 press 9, at the password prompt enter 73738767793 (resetsmpwsd) and press ok or #,press yes to reset password. password should be defaulted to 0000. then try Feature 983. if your system has 2 digit intercom #s your password is 120000. 1020000 if you have 3 digit intercom numbers

the startalk takes does not store the time, it takes the time and date from the phone system. to change the time on the phone system try feature **TIME (8463) password CONFIG (266344) from a phone with the 3 soft buttons under the display it does depend on the model and software level as to whether this will work and also presuming nobody has changed the default password

to reset the administrator pasword enter feature 985 press 9, at the password prompt enter 73738767793 (resetsmpwsd) and press ok or #,press yes to reset password. password should be defaulted to 0000. then try Feature 983. if your system has 2 digit intercom #s your password is 120000.
If you have 3 digit intercom #s then the password is 1020000.

The Star Talk Flash is a voice mail prduct. The caller ID feature is a phone system feature. If your system is a norstar CICS or a MICS the caller ID will work only if you have the caller ID capable central office circuit packs installed. Look on the card and see if the label has "CLID". If it dose there is also additional programming required for each set under.... terminals &sets/telco features/featue assignments/show line/caller ID...set:Y. You also have to program (under sets) /telco features/caller ID: Y.

Hope this helps.

enter feature 984
the display should say log:
enter 1020000 and press ok
display should say <date>
press next if ok or chng if not
display should say enter hhmm:
enter time in 12 hour format
display should say retry am pm
press applicable key
press next then Rls

You must initialize the general delivery mailbox. Dial into mail box 100 and record a name.

Dan

Once in the AA menu of f983 there is a setting for day and night based on the time and day of the week.

These should help you out.


http://pdf.textfiles.com/manuals/TELECOM-S-Z/Startalk%20Flash%20setup%20and%20operation.PDF

http://pdf.textfiles.com/manuals/TELECOM-S-Z/Startalk%20Mini%20install%20guide.PDF