Minolta 206 not going to power saving mode - Minolta Office Equipment & Supplies

Its a black unit error code
It means the black toner is not supplying to d developer you can reset error code by logging in d service mode

https://www.youtube.com/watch?v=XTLiKkwg4zk

fix problem konica minolta bizhub 206 226 195 C221 215 maintenance call m2

https://www.youtube.com/watch?v=XTLiKkwg4zk

fix problem konica minolta bizhub 206 226 195 C221 215 maintenance call m2


Or telephone a service provider (that is, a service call) to repair it.

FIXING HEAT UP ERROR

RESET BY OFF AND ON BY HOLDING UTILITY BUTTON OR RESET BUTTON

Go to service mode and clear the counter

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Increase its power save time.Go to utility/Counter, then press check details, then select administrator mode, then enter password 12345678, now in copier setting or in system setting increase the power save time of your machine.It will not resume again.

c-206 this code means third tray lift up abnormality. call technical service representative.

I have this same problem. Its not an issue of permissions as neither my user who has Administrator rights locally and my domain admin account get the same message. I also tried deleting the GoToMeeting folder outright and still get the same error. (although it does re-create the folder for me)

Hi:

Hold down the 0 and 8 keys while turning on the copier. Keep on holding down the keys until the screen shows a adjustment mode screen. Once it does this key in 205 then you should see a numeric value. Input 15 and press start to lock it in This will change you power saver mode to 60 minutes. Next enter code 206. Key in 19 and press start. This will change your sleep mode to 240 minutes. These are the setting that are most generally used when these copiers are initially set up. Then just turn the copier off and back on. I hope this resolves your problem.

Good Luck

Andrew

Yes you can change the power save mode. I don’t remember from where you can change it. but its easy for you if you get the all operation manual list form the printer, get the setting page from printer by pressing the menu from your printer then you will get all commands so then you can change all settings of your printer.