How do I keep Craig TV on constantly, not shut down after 12 or 24 hour period?

I have a plasma that does the same thing. I don't know but have been told it is probably the power supply.

Sorry but you are just going to have to keep emptying it. These types or air conditioners are also use as de-humidifiers and unless you can place it somewhere where you can connect a drain hose it is going to require many trips to dump the holding tank of the condensation.

Most cable supplies provide a switched receptacle on the rear of their cable boxes. Plug the power supply for the tv in there if you want the cable box to shut the tv off when you shut the cable box off.

From your description it sounds like you TV is experiencing a shut down and re-set condition. This is usually caused by some type of voltage irregularity in the power supply section of the TV. Unfortunately, this is not an easy fix and will require a trip to the shop. Get an estimate before approving repair. In the new world of disposable electronics the cost of repair may exceed the value of the set. Keep in mind that TV components are most prone to failure during the electrical surge when you turn the TV on. So constantly pushing the on button will accelerate a permanent failure.

YOU WILL NEED TO REPLACE YOUR PROJECTOR LAMP #BP96-01472A AND THIS SHOULD RESOLVE YOUR ISSUE.
HOPE THIS HELPS

this is called a swing tempature it is desined to improve the eficincey of the frnace because it take less energy to run an hour in a three hours then 3 bursts of 25 min in a three hour period

HOWEVER if you do not like this you can usualy set the swing temp

hay if you fell it getting hot fast it's the heat transfer compound in the system which is wearing away causing it to over heat and shut down as a safety precaution. so there for it will keep freezing of shouting down.

Do you see any deteriation of picture quality before shut down ? This could be a number of diff problems. Need more info
Craig www.classtorations.com

replace the lamp part # BP96-00826A. if the lamp code on the side of the set is different replace with that lamp. you will need a tech to reset the lamp hour meter in the factory mode.

My TV is shutting off after you turn it on.Model #27MT5005D.
The light continue to blink, but thats it.