The problem is with my uniden phone model D1364 can't hear the tone when dialing phone

You can download the manual at
http://www.home-electronics.net/USER-GUIDES/26928_DOM_ES_CL_IB.pdf

Select the model of your phone from the list at
http://uniden.com/index/manuals_results.cfm?cat=59

Uniden offered a replacement, stating that the base phone was probable beyond repair.

Please disconnect your cordless phones from telephone jacks throughout the home. The "line in use" is say that you have a short on the line, or a phone off the hook. So disconnect lines, then replug 1 corded phone in to check for dial tone. If working, continue to plug in 1 phone at a time(rechecking working one each time) to find the equipment that is causing you heartache.

1) When the phone is in standby mode, press and hold the caller id/menu key.
2) Press the vol/ / key three times to select Dial.
3) Press the select key to toggle between Tone and Pulse.
4) Press the end key or return the handset to the base unit to complete the setting. The handset returns to standby mode.

This phone also has a feature that allows you to use Pulse dialing to make calls, but allows you to switch to tone dialing for automated systems (like “Please Press 1 for English) here are the steps for that:

Initially make your call with the pulse dialing mode. Once your call connects, press
the */tone key. Enter the desired number. These digits will be sent as tone dialing.
Once the call ends, the tone mode is canceled and pulse dialing mode resumes.

The problem was the main phone line not the phone itself

Activating Call Forwarding

You can activate Call Forwarding whenever you want your calls to be sent to another phone, including a mobile phone. Once activated, all your calls will be sent to the forwarding number you request. Each time a call is forwarded, you will hear one short reminder tone on your home phone, but you will not be able to answer the call from your home number.

1. Lift your telephone's receiver and listen for a dial tone.


2. Press *7 2.
In some areas you must use 72#
Dial 1172 on rotary or pulse-dialing phones.


3. At the tone, dial the telephone number where you want your calls transferred.
You will hear the number you entered ring. When the number is answered, Call Forwarding is activated.


4. If the call is not answered or the line is busy, hang up and call the number again within two minutes.
You will hear two short tones telling you that Call Forwarding is activated.


5. Hang up the receiver.

Deactivating Call Forwarding

Turn Call Forwarding off when you want to receive calls on your home phone.

1. Lift your telephone's receiver and listen for a dial tone.


2. Press * 73.
In some areas you must use 73#
Dial 1173 on rotary or pulse-dialing phones.


3. Listen for two short tones.
Call Forwarding is now off and you will receive your calls at your home number.

no dial tone. the handset shows "searching".

try pulling the batteries out for 24 hours and then putting them back in. It should reset all the software and it should sync back up.

Lisa, If the 900MHZ phone is Model 26928M programming for rotary dial usually goes like below, can't hurt to try on any model. TONE/PULSE DIALING This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing. The phone is pre-set for touch-tone use. To set to tone or pulse dialing: 1. Press and hold the program button for two seconds. You will hear a beep. 2. Press the *tone button to select Tone Dialing or press #pause to select Pulse Dialing. 3. Press the program button again. You will hear a confirmation tone.