I fell alseep one night with the tv on. It was storming. I woke up and the tv was off. I tried turing it back on and it wont. I tried new plugins and everything and still nothing. What can this be.
If the set turns on for a while, then shuts down, there is a problem internally that is being detected. The set has a num,ber of error detection circuits that will cause that shutdown to prevent further damage, You can try a "reset" if you like, but I doubt it will help. The easiest way to do this is to unplug the set for at least an hour. More than likely, the set has a number of poor solder connections and possibly defective parts. If you can solder, try resoldering any connections on the board that appear to be grainy or have rings. Update this with your results.
Dan
A FUSE
The Fuse is Located inside the television set but sinse you state that the set powers on but then powers down after a time , that means you do not have a blown fuse , but may have another issue.
The User Manual Link to solve your reset issue.
http://us.sanyo.com/entertainment/televisions/stereo/downloads/DS27425%20DS32225_0201A-(ENG).pdf
Az.
2,666 views
Usually answered in minutes!
Sanyo DS32225 32" will not turn on. It turned on this morning after a slight delay.
A fuse? Where is it?
Sanyo's help line has a recording....someone will answer in 3 minutes.....that was 20 minutew ago. The recording mentions a reset button on the remote which I have probably lost. Is there a reset button on the tv? Can't find one.
Thanks,
Mike
I DO HAVE A TV 26" SANYO I TRY TO TURN IT ON IT DID BUT 7 SECONDS LATER SHUT OFF AND IT KEEP DOING IT ANY SUGGESTIONS? THANKS
i left my tv on for a long time then it turn off by itself and when tryed to turn it back on there was no picture then turned off again by itself
my tv will turn on and off but the next day it will not come on at all i was about to put it in the shop after a week but i plugged it in and it worked fine and there it did it again any ideas ?
×