RL-01CTV RECONNECTING CUT WIRRE

Either the regulator in the alternator is acting up, or there is a problem in the engine computer.

It is under the car at the rear. Here is the procedure to remove it.
Removal

1. Ensure you have the anti-theft codes for the radio and the navigation system, write down the frequencies for the radio's preset buttons.

NOTE:
The PCM memory setting is needed after reconnecting the battery.

2. Disconnect the battery negative terminal, disconnect the positive terminal.

3. Raise the coolant reservoir. Remove the battery and battery base.

4. Remove the alternator belt and alternator.

5. Remove the left exhaust manifold cover.

6. Remove the left damper fork.

7. Disconnect the left suspension lower arm ball joint.

8. Remove the left axle shaft.

9. Remove the transmission stop collar, and remove the exhaust pipe.

10. Remove the front mount mounting bolts.

11. Attach the chain hoist to the engine.

12. Remove the left engine mount bracket.

13. Disconnect the starter cable and BLK/WHT wire, remove the starter.

Did you resplice the cut wires with solder and shrink wrap - try that first. Then reset the car by disconnecting battery for 30 minutes and reconnect. You want the ecm to re-boot.

The question can you get a new one in. you can always cut the old one up enough to get it out. In the past, I've skipped the factory hose and put in a completely flexilbe one. You can have flexible hydraulic hoses made up at most truck shops. The only thing critical is the end connectors. You might even be able to save the old ones and splice in a hose.

Sorry but we have no wiring diagram here for this car.

The people who answer questions on this website do it for free.
We have some books, but not an entire library of every book known to man.
My standard answer to this question is - there are two ports on the ac lines or the compressor with plastic caps. One is bigger than the other to help prevent you from hooking up to the wrong side of the compressor.
That's the best I can do since I can't see your car.

the problem is with the cpu .there is a wirre which connects ur cpu and motherboard. that wire is not properly fixed or might have got lossen.go to services person to fix it

it would be much easier and cheaper if you write down your VIN and take it to a local Acura dealership . They can cut you a new key for ten to $15.00 .

Get the facia kit, Acc+ and Gnd are tapped off the cigarette lighter Batt+ is found in the BLUE plug behind the interior fuse box. Speakers FL, RL, RR are found behind the glove box and the FR speaker in the drivers kick panel. There are also other precautions to take when installing it to avoid frying the ICC computer which controls all the interior. When attaching speaker wires ensure you connect the correct side behind the glove box connect the left side of the cut and in the drivers kick panel connect the right side of the cut. Speaker wire colours are Grey FR, Orange FL, Pink RR & Blue RL. All speaker wires are twisted together. Influential Customs

it could be window lifter broken