Washer will not spin . if run on any wash cycle, will fill for 5 seconds, pause for 45 seconds, fill for 5 seconds, pause for 45...
Had same problem with GE wssh300 front load washer. Removed two screws from front bottom panel (under washer front). Pulled off panel, loosened screw from a seal ring on the rubber flex hose going to a 4" square plastic housing. Reached down inside and found a ton of lint (probaby a 2" balls worth) jamming outlet. Removed lint an works geat. Very easy to do by tilting front of washer up and putting supports under front to keep elevated. Be careful to make sure supports are sturdy washer can't dop when servicing.
Plug off the wall. Clean out your outlet filter. Access is a door in the front bottom of your machine, be prepared for some water to come out. Refit.
WOW - I pulled out ton of lint and probably $5 in change. THANKS
Kelwrizzt's solution was spot on. My blockage wasn't caused by lint, but the underwire from one of my girlfriend's bras. That and a few weed eater strings. So I guess we're both at fault. Thanks a ton.
Praise the Lord! I think it worked!! I pulled out a swelled, black, goopy, smelly nursing pad out of the outlet filter along with a quarter, some, screws, several bobby pins, and a Wendy's straw wrapper.
2,026 views
Usually answered in minutes!
thanks boss but it turns out it's the computer module in the back according to troubleshoot codes .
I have the very same problem...It tumbles but no spin in spin cycle...
my problem may be the same. It will fill with water but then when it's time to start to begin spinning the wash it will spin only three-quarter of the way and stop. I put it on spin only and it does the same thing. I can hear the motor trying to do something but no full spin or advance to the rest of the cycle. PLEASE HELP.
×