I have a Roper Dryer Mod# REX5634KQ1. It just

Question edited for clarity.

It is here

Im looking for the electrical schematic for my dryer. Its a

JustAnswer https://www.justanswer.com > ... > Appliance Repair
Oct 22, 2017 · 1 answer
Its a roper model: rex5634kq1, type: d433-ele-2406028-fm54. ... OK attached is the wiring diagram for your dryer.

what make is the dryer

what stopped? Does it not Spin? if so it could need a new motor. If it spins but doesn't heat up. it could just be a heat sensor in the back that needs to be replaced or a heating element. if nothing happens at all it could be the start button needs to be replaced. Turn the dryer around and open up the top back panel. should be about 6 screws. inside there will be a diagram on the schematics of the dryer.

Hope this helps.

Check to make sure that the dryer vent is clean or open. Make sure the dryer lint screen will let air through it...... take it to the kitchen sink and run water through it if water runs through it easily it is OK if it holds water then clean it with dishsoap and try again..... The dry is not getting enough air passed through the dryer.... Also I am assuming that the Washer is wringing out all of the water from the clothes.

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

if the timer does not move it needs a new timer

try runing your dryer with out the vent hose.if your dryer wooks well than you have a problem from were the vent hose hooks up to your dryer and the outside vent.

replace your t-fuse again but also chekc to see if the vent going outside is restricted. if hte vent is smashed or clogged the heat has nowhere to go. i would say that is your issue. clean your vent before you change he t-fuse.

The vent may be stopped up, or the vent hose crimped so the air cannot escape, you can check the air flow at the vent on the outside of the house while the dryer is running.
try cleaning the vent and the lint screen with a vacuum cleaner, you may need to replace the vent hose, this should solve the problem

if its not heating at all the thermal is the most likely culprit and it was the little plastic piece you seen now if you have a meter set it to continuity and pull one of the wires off the thermal limiter and check it if it reads open its bad same with the heating element let me know now if the heater and thermal limiter are good pull the blower motor vent and check it for blockage