Canon FS100 Flash Media Camcorder Logo

Related Topics:

Anonymous Posted on Aug 13, 2013

It will only display a black screen on picture and video mode, but displays pre-recorded videos and images just fine. We did not ever let it get near water, or be dropped since we got it. We got it from eBay used for $ 50.00 and worked for months until now. Please Help!

5 Related Answers

Anonymous

  • 3130 Answers
  • Posted on Mar 21, 2007

SOURCE: no picture

In the first half of October, 2005, a number of digital camera and camcorder manufacturers issued service advisories involving a range of digital camera models (as well as some digital camcorders and PDAs that incorporate image sensors). In each case, the story was similar - CCD (image sensor) failures, particularly in conditions of high heat and humidity, led to cameras capturing images with either no picture at all, or with extreme distortion and severe purple or green color casts. An example of the latter symptom, courtesy of the Konica Minolta Europe website, can be seen further down this page. We first started hearing about this problem in late September and early October, 2005, with a significant increase in reader emails about it in the first week of October. The problem understandably caused considerable concern among our readers, with many wondering whether this was an ongoing problem that could affect current cameras. Initial service advisories by Sony, Canon, Fujifilm and Konica Minolta were soon followed by announcements by Nikon, Ricoh, and Olympus. Affected cameras were all manufactured between 2002 and 2004, the underlying problems have apparently been found and corrected, so no cameras currently on the market are affected. (We are assured by sources that new cameras purchased today will not be affected by this problem. See the "What caused this problem" section at the bottom of this document, for a more detailed discussion of possible causes.) We here at Imaging Resource did a little digging into the problem, and it appears that the problems trace to certain models of image sensor chips manufactured by Sony between 2002 and 2004. (Fujifilm has stated that they manufacture their own CCD chips, so it's not clear whether or not the problems with their cameras are in fact related to those of the other makers.) The problem can take any of several forms, but all involve severe color shifts and/or severe distortions of the image. The images below show two examples (courtesy of Konica Minolta) of what the problem might look like, if your camera falls prey to it. In the early stages of the problem, the camera may still capture recognizable images, but with a washed-out appearance and a strong magenta or green tint What products may be affected? Quite a number of products may develop this problem, including digital cameras, camcorders, and even PDAs (Personal Digital Assistants) that incorporate an image sensor. The following is a list of affected models by various manufacturers that we are presently aware of. We will update this list as new information becomes available. We recommend that you check the site regularly for this and other breaking news. Here are lists of the affected products, grouped by manufacturer: Canon Digital Cameras Camcorders PowerShot A60 PowerShot A70 PowerShot A75 PowerShot A300 PowerShot A310 PowerShot S230 Digital ELPH / Digital IXUS V3 / IXY D320 PowerShot SD100 Digital ELPH / Digital IXUS II / IXY Digital 30 PowerShot SD110 Digital ELPH / Digital IXUS IIs / IXY Digital 30a Additional digital cameras added in the fall of 2006 to the original service advisory by Canon include the following, all of which went on sale starting from 2002 to 2004, depending on the specific model: PowerShot A40 PowerShot A80 PowerShot A85 PowerShot A95 PowerShot S1 IS PowerShot S60 PowerShot S200 DIGITAL ELPH / DIGITAL IXUS V2 / IXY DIGITAL 200a PowerShot S330 DIGITAL ELPH / DIGITAL IXUS 330 / IXY DIGITAL 300a PowerShot S400 DIGITAL ELPH / DIGITAL IXUS 400 / IXY DIGITAL 400 PowerShot S410 DIGITAL ELPH / DIGITAL IXUS 430 / IXY DIGITAL 450 PowerShot S500 DIGITAL ELPH / DIGITAL IXUS 500 / IXY DIGITAL 500 (including White Limited version) MV600i MV630i MV650i MV700i MV730i MV750i MV5i MV5i MC MV6i MC ZR60 ZR65 MC ZR70 MC ZR80 ZR85 ZR90 Elura 40 MC Elura 50 According to the updated advisory, available on the company's US website (as well as other regional Canon websites), the additional eleven digital camera models shown above in red may now be eligible for free service regardless of warranty status, should any malfunction be caused by the CCD sensor. For repair instructions, visit the Canon USA support website. To read the specific service advisory for your model, use the pulldown menus to browse for your specific model, or simply type the model number into the box provided at the bottom of the page and click the "Search" button. The Canon support website holds no forms or other needed documents, so you can save yourself some time (if you live in the US or Puerto Rico) by just calling the Canon Customer Support line at 1-800-828-4040. Support hours are Monday-Friday 8am to 12 midnight, and Saturday from 10am-8pm. (All times EST.) Alternately, you can send email to: [email protected].

Ad
A

Anonymous

  • Posted on May 12, 2007

SOURCE: Camera records no video

Hi John, my 730i is driving me mad too http://www.dpreview.com/news/0510/05100602canon_ccdproblem.asp this might help us both. Steve

Anonymous

  • 1 Answer
  • Posted on May 07, 2009

SOURCE: no picture

If you want to have it done for free check the canon service note - it may help and will not cost you a broken penny. http://www.usa.canon.com/consumer/controller?act=PgComSmModDisplayAct&fcategoryid=227&modelid=9740&keycode=2112&id=48266

zohail

Shoaib Rais

  • 1223 Answers
  • Posted on May 25, 2009

SOURCE: Grey lines across video display

pls rate me WELL if i have helped u !

Regards

Zohail

Anonymous

  • 172 Answers
  • Posted on Aug 11, 2009

SOURCE: Camera is on, no picture

what mode is the camera in?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

The text along the sides of the tv screen are not completely in view

you need to change the 'zoom' on the tv by the remote.
Normal mode frames the 4:3 video to the 16:9 picture area by displaying it in its original aspect ratio, with vertical gray or black bars on both sides of the screen. The disadvantage of this method is the fact that the image is small by virtue of not using the entire width of the screen. This is also known as the 4:3 mode.
Full mode Full mode horizontally stretches the 4:3 video evenly across the entire width of the screen. This is the proper mode to display anamorphic video. If used for standard aspect ratio video, everything on the screen will appear wider than normal. Contrast this with anamorphic video displayed without processing on a 4:3 display, in which people on the screen will appear taller than normal. This is also known as the 16:9 mode.
Zoom mode Zoom mode evenly stretches the picture both horizontally and vertically, until the picture fills the entire width of the screen. This crops out the top and bottom of the picture. This mode is used for letterboxed and open matte video.
14:9 mode Main article: 14:9
In 14:9 mode, the picture is magnified more than in Normal mode, but less than in Zoom mode, while retaining the original aspect ratio.
Wide Zoom mode Wide Zoom mode, also called Just mode, Horizon, or Smart Stretch, progressively stretches the picture horizontally, less in the middle and more on the edges. This allows normal aspect ratio video to be displayed across the entire width of the screen, with minimal cropping, and with much less of the unpleasing visual stretching effect of Full mode.
2helpful
1answer

Canon Power Shot A560-My camera will allow me to see images when recording video, but I cannot see images when I want to take a picture. The screen is completely black. Not sure what happened. It has...

Sounds like you just accidentally pressed the DISP or DISPLAY button on the back of your camera. This turns the screen on and off in photo mode to save batteries (you'd then use the optical viewfinder in its place). Just press the button one more time with the camera turned on.
0helpful
1answer

On picture taking mode, screen is black but can still take pictures

Please provide more detail about your problem.

Does the screen play back the pictures ok but not during record mode? Or is it off all the time and you used a computer to review the shots that were taken?

Check the basics listed below:

1. The screen may be switched off.
Press the display button on the back while the camera is on. This toggles the display setting between various settings such as Off/ On / Info. Keep pressing the button to try the aternate modes, it just goes round and round to 2 -3 different modes.


2, Check that the monitor brightness setting is set to medium at least in the menu's.

3. If the problem is only affecting recording then check that the main record settings are correct for the type of scene you are taking. For example don't use Beach, Snow, Candle or manual with a high shutter speed while taking regular daylight shots with minimal lighting.

. 4. If the LCD display has a hardware issue you could connect the camera to a TV using the video output jack and look at it that way. Then you'll know if the built-in LCD is ok or not.

5. Having a damaged or stuck video output jack COULD cause this problem also since that circuitry is designed to automatically shut off the built-in LCD display when you connect a video cord to it. Note that having a video cable plugged in to the video output jack would shut off the display also. Such as when you have it connected to a TV.

.
0helpful
1answer

Last winter I dropped my Canon FS100, and the LCD screen would only display black or a grey strobe in camera mode. After a week of what seemed to be repeated attempts to reboot, it "healed" itself! Now a...

It might be that she damaged the lens where you just got it slightly wet. damaged the lens or the CCD that receives the image itself. it might not be repairable at all, If its a case of water damage remove all power sources from it and use a hair dryer on low for a while to dry it out " make sure the screen itself does not heat up to much and focus on the lens. You may have to replace the camera or contact a repair person. I myself give any repair a try and most things with a little luck can be saved.
0helpful
1answer

Display shows a set of black bars

tape guides are out of adjustment, need to have brought in for service.
0helpful
2answers

Camera mode recording/displaying right

what is the model number? if it's 10 years or older you are most likely dealing with bad surface mounted capacitors.
1helpful
1answer

LCD won't project

You may have a problem with the image sensor device (CCD). From October 3, 2005 through October 2, 2007, Sony will repair, free of charge, affected products exhibiting the above-mentioned problem where it is caused by the image sensor device. Sony will also cover the cost of shipping and handling from and to addresses within the United States and US Territories for service to correct this issue. To see if you have this problem: Power On your camcorder (make sure the battery is fully charged). Check the LCD screen and verify that the display icons are turned on. If you cannot see the icons, press the Display button until the icons are visible. Put a tape in the camcorder. With the lens cap off, record some video. NOTE: Be sure to speak during the recording so the video will contain your voice. Rewind this section of the tape (using tape counter to verify start of your recording). Play back the recorded video and use the LCD screen on the camcorder to view it. You should hear the audio you recorded and the Display icons/text will still appear. If your camcorder is affected by this CCD issue, the picture will either be extremely distorted, or there will be no visible picture (just a blank LCD screen with the display icons still visible).
0helpful
3answers

Sony F55 Recorded Display

The filename (e.g. DSC0012.jpg) shows the image number, the filespec shows the date and time recorded. Most software will give you document info about resolution of the image. I wouldn't worry about what the battery status was when the shot was taken or how many other images were on the Mstick. I guess I'm not sure what you need.
Not finding what you are looking for?

180 views

Ask a Question

Usually answered in minutes!

Top Canon Video Cameras Experts

Brad Brown

Level 3 Expert

19187 Answers

NOEL
NOEL

Level 3 Expert

8606 Answers

john h

Level 3 Expert

29494 Answers

Are you a Canon Video Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...