Push button controls for Rangemaster kitchen hood don't work

What is the model number of the unit?

Hello, when you turn on one of the burner, can you hear some clicking while you turn on one of the burners? This is an electric ignitor, and when you turn one burner on all the burner ignitor will click.


It is possible, that you are turning your burners on the stove to quick. Take a look at one of knobs and you will see ignition--low---medium---high. To get the burning ignited the knob needs to be position at the ignition site. You'll hear it click-click-click and the burner will ignite.



Now, the oven. The oven ignitor is on a time delay. You will push the bake button and across the screen will say something like this "Please set oven temperature" You'll set the oven temperature to---let say 350 degrees---. Then the screen will say "push start button" then you push the start button to turn your oven on. Now, the screen will say "pre" this means that the oven is pre-heating the oven to your desired temperature. Before all this happens there is ignitor in the oven and it has a heater on the ignitor in oven. This heater will heat up to desired temperature and once it reaches the that temperature the ignitor will ignite and the gas will turn on.



Why--one would say for this procedure. The old kitchen stoves had a very bad habit of of flash over---that is gas will built up in the over and once the pilot light ignited the gas---wussh and it blow the oven door open. These ovens would sometimes huff too.



Therefore, take your time and your biscuit will be OK



*************************************************************************************************************

*************************************************************************************************************











I am sorry Sandan2. I didn't finish reading your question. Never mind on what I said here.

If the burners will not shut off sometimes, then there could a gas regulator problem.



One very important question. Is your kitchen stove using Natural Gas or LPG--liquid Petroleum Gas?



If it is using either type of fuel as mention above. It is very important that you contact Appliance repair person that is certified by the state that you live in that he/she is license by the state to work with gas appliances.

I wish you luck, but it very it important that you contact a certified Technician... Also, move the stove away from the wall and look behind it. There a black gas pipe and at the end is a brass valve, Take wrench and turn the gas valve off. The gas valve will have a stainless steel flex line attached to it, and the other end is to your stove. Don't use your stove.



If those gas burners and the oven are leaking gas. There is possibility to blow you and your family with your home up. Don't use the stove, Until you have it check out...please. GB you/your family...stewbison

lift the push button up a bit if dont work u need to replace the push button. bsc appliances uk...07779933829 postal service too.

DO YOU HAVE GAS IN THE TANK, AND IS THIS A NEW STOVE, AND HOW OLD IS IT IF ITS NOT BRAND NEW, THE PILOT MAY BE OUT.

push the button on the front of the stove that says "clock" and then turn the dial (same one you use for timer and oven temp) till you get the time you want, then LEAVE IT ALONE and it will set itself. Don't touch anything once you have the time set with the knob.

It is part of the control board. You will have to replace the whole board and there is soldering involved. Best to call an appliance repair company.

rangemaster have a tech help desk. you can find the number on the internet.

tru appliance parts site like repairclinic.com

Mother board (control unit) is faulty.

zepher sent replacement sritch.
had to wait a while -parts from italy (heh)
so far ok
design is poor