Hotpoint DW440 flashiing lights

If your Hotpoint FDEU 9640 washer-dryer is stopping prematurely during the dry cycle with all the LEDs flashing amber, it could be caused by a few different issues:

1. Check the filter: Make sure the filter is clean and not blocked. A blocked filter can cause the machine to stop working properly.
2. Check the venting: Make sure the venting system is clear and not blocked. A blocked vent can cause the machine to overheat and stop working.
3. Check the heating element: If the heating element is faulty, it can cause the machine to overheat and stop working.
4. Check the thermostat: If the thermostat is faulty, it can cause the machine to overheat and stop working.
5. Check the control board: The control board controls the various functions of the washer-dryer. If it is faulty, it can cause the machine to stop working.
6. If none of the above steps work, it is possible that the machine has a more serious problem that requires professional service.

It is important to refer to the user manual or contact Hotpoint technical support for further assistance and specific troubleshooting steps for your washer-dryer model. It is also important to make sure the machine is not plugged in before attempting any troubleshooting steps. It is also important to note that it is not safe to use a multimeter to test any of the heating element or thermostat

press and hold on off button till the display panel lights up.Then press and hold the on/off button and the start /cancel button together.You will now reset the washing machine settings.And just pick your cycle again

Check first the thermal fuse.

Test heating element to ensure is not grounded, and staying always on. Test the fan and ventilation system.

If you find no fault in there , then test the timer control board.

Enter the model number on one of two websites below to get parts and diagrams for your appliance:


Appliance Parts From PartSelect

Appliance Parts Pros

Yes I have the same problem but the Drying High Heat is also flashing

I have a fairly new Hotpoint Aquarius machine (out of guarantee).
When it is switched on, all of the red lights flash and it will not operate.
Can you help please ??

This is more a workaround than a solution. When you choose the washing programme (say "D") and push the on/off button, two lights will flash, the "door locked" and the "drying" one. Now turn the "drying programme" button until the "drying" light stops flashing (in my case, this is true when I set the drying programme to 40°C). Then start the washing mashine.

Seems like the function of the drying programme button has shifted against the settings written on the button...don't ask me why! Of course, no guarantee but works for me. Please let me know if it does for you.

the printed circuit board is gone

For mine, it started flashing the on/off light along with the "drying high heat" and the "reduce crease".
Unplugging the unit for 30 minutes appears to have reset the machine and it is now working.

Filter blocked, disconnect hose from under sink connection and drain into bucket. Hotpoint does not want you to change filter, contact Service Engineer.

I SWITH ON THE MACHINE AND F 01 APPEARS