Site note responding

Pentax 540fgz not turn on issue after leaving it off for a while.

I have just this issue of ....

flash unit dose not respond in a any way when loading batteries into it.

lcd dose not respond. Flash dose not charge at all.

my problem turned out to be corrosion on the terminals and a poor door design and corrosion on ternminals.

patch fix.

rotate batteries on terminals to clean contacts them use a bandaid and bandaid to tape door shut.

long term fix take terminal plate off door clean and bend terminal plate so it contacts batteries better.

check the turbo for operation and check the cat converter for failure and blocking the exhaust system

Probably needs a new receiver. This is the kind of low-end stuff you get when you buy a store brand.

The sled motor to your player might be faulty.

Visit this site for more details. Type in the site name "Electro-help" either Google or Yahoo search box [not in the address bar of your browser], and click search. It is an electronic equipments service help site. All details you want are there. Note the position of hyphen in between words in site name, when you type it in. The site will appear as it is in web; subtitled as electronics equipments' repair help.

Visit this site for more details. Type in the site name Electro-help either to Google or Yahoo search box [not in the address bar of your browser], and click search. It is an electronic equipments service help site. All details you want are there. Note the position of hyphen in between words in site name, when you type it in. The site will appear as it is in web; subtitled as electronics equipments' repair help.

Visit this site for more details. If you can repair your remote control, instructions to do are given. In most cases, cleaning the remote will make it right. Site name is "Electro-help". Type in this site name, either to search box of Google or Yahoo and click search. It is powered by Google. Pull up the older posts there. Note the hyphen in between words of the site name. Open the site with same name.

Try letting the program run for a while if it dose not respond after about 2 to 3 mins then only close it.

There may be some software problem or maybe your explorer.exe is going to get corrupt.

Enter your Yahoo! ID and password and click the "Sign In" button.

you may have a registry problem download registry cleaner reginout to fix the issue

Yes you will need to update the firm ware if this dose not fix the problem you will need to replace the control panel screen, if this dose not work you may have to replace the mfp board

Hi abdumi0f,

Firstly, open your glove box and make sure Valet Mode is not enabled, if it is not, follow these steps.

Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the driver’s door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.
Step 5: Open and close the driver’s door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1 twice. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) twice. Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done!

Hope this helps,

Lazaruselite