HI, I have a Konica 7020. It is showing code 'F-35-1'.

Yes I stated what I recommended to do in your last post!

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Did you blow it up, probably not.

Click this link for the everything.

http://www.kmbs.konicaminolta.us/content/support/supporthome.html

1. Choose the Category "Office Systems"
2. Choose the model "7020"
3. Click the error next to the Model dropdown box.
4. Choose the 1876KB user manual called "User Manual for 7020, 7025, 7030 and 7035"

Or click on this link for the specific manual.

The error codes you seek are not in the manual, you'll have to call Konica to tell you what they are ... call Konica at (860) 683-2222.

Hope this helps. Rate a fixya!

check finisher door sensor

dear need help to resite l detect value auto adjustment developer konica 7020

The printer stops working & showed me an error code F-26-1

www.fixya.com/.../t16683015-printer_stops_working_amp_showed_me

Feb 20, 2013 - the printer stops working & showed me an error code F-26-1 , How can I repair it ? I think it s relating to a - Konica Minolta 26NA53040 7130 ...

Konica Minolta 26NA53040... Repair Questions - Fixya

www.fixya.com/.../p4700437-konica_minolta_26na53040_7130_7025_...

Konica Minolta 26NA53040 7130 7025 7020 Oem Lower Fixing Roller Assy New ... Theprinter stops working & showed me an error code F-26-1 , How can I ...

This 51-4 code is directly related to the write unit. It can either be a bad lazer index control board mounted externally to the side of the write unit or a bad M5 polygon motor. It is better to replace the whole write unit. Konica P# 26WA-6500.
On a side note, the 7020 write unit can be used in place of the 7022 write unit & is far less prone to failure then the 7022 write unit! 7020 write unit Konica P# 26NA-6500.

hi
error f 35 is fixing error,try to reset on 25 mode

need to rest code 25 mode dip switch 3-1 should be 0
hope that help
let me know if you need more help with access

35-9 is a low temperature error in the fuser.If the fuser has a problem it will not make a copy period.Sorry. Mrbonz

HI,
you need to reset the fuser latch as it has a fuser error code most likely needs new thermisters,
anyways give this a go, hold down 2 and 5 keys together and power on machine, this will put you into to a service mode call 25 mode, go to dip switch 3 and bit 1 and then next to bit 1 hit the key that says turn off,
turn machine off and back on should clear error code, if it doesnt you need new thermisters, even when you put in new thermisters you still need to clear this error in service mode
Regards
Konica Tech