I need a code to work my Hitachi 32LD8D20U from my Sky Remote and Sky can't find one

https://helpforum.sky.com/t5/Sky/Sky-HD-remote-code-for-a-Hitachi-43hb26t72u/td-p/2899528 should work

0104 0107 0110 0119 0126 0127 0150 0152 0161. Try these codes. If you wish to get more; check the site linked here. It has set-up code list & set-up procedure to many popular brand remote controls. See it in "Mosaic" view. It will make surf easier.
http://electrohelponline.blogspot.com/

If the set have a 'Menu" button on its front panel, you can so this. If not, you must have a remote control to make it autotune.

The correct code is 1065. Worked for me on HITACHI L42VK04U

http://www.tv-wall-brackets.co.uk/hitachi/32_inch/32LD8D20U/

hope this link gives u some information


All the best

Thank You

hi need code for sky+ remote to use on hitachi L42VPO1U

I own a One-for-All universal remote (model URC-4220), and my booklet says the setup code for a Hitachi TV is either 0000 or 0145. If these numbers do not work, then I would buy a newer universal remote. They can purchased at Walmart for less than 10 dollars.

The code you need is 0145

1) Switch on the TV set
2) Press the TV button on the Sky Remote
3) Hold down the select and red buttons for 2-3 seconds until the LED blinks twice
4) Press the TV button on the Sky Remote again
5) Enter the 4 digit code for your make of TV
6) The LED should blink twice, if not recheck the 4 digit code used and go back to 1
7) Press the standby button on the Sky Remote (The TV should go to standby)
8) Press select to store this setting
If the TV does not go into standby press the TV button then the standby button, then TV then standby, keep repeating this until successful. This will scan the codes used for a particular make of TV.

You won't be able to use it for your dvd player unfortunately.

The code for sky is 0145.

1) Switch on the TV set
2) Press the TV button on the Sky Remote
3) Hold down the select and red buttons for 2-3 seconds until the LED blinks twice
4) Press the TV button on the Sky Remote again
5) Enter the 4 digit code for your make of TV
6) The LED should blink twice, if not recheck the 4 digit code used and go back to 1
7) Press the standby button on the Sky Remote (The TV should go to standby)
8) Press select to store this setting
If the TV does not go into standby press the TV button then the standby button, then TV then standby, keep repeating this until successful.

Gaz

x37sv-naga.lcd remote control