Razor E100 Electric Scooter - Page 2 - Answered Questions & Fixed issues

Could be the battery. Put the Scooter on a block so the rear tire is raised. Remove the standing plate to reveal the battery compartment. Charge the Unit completely 1. Using a multimeter measure the voltage across the batteries. If the voltage is below 20 volts batteries are dead - Replace batteries. 2. Now for a running test. Turn the throttle and spin the rear tire to preform a kick start. Still measuring the voltage. If the voltage is Below 20 volts or if the voltage drops quickly batteries are dead - Replace batteries. 3. If the voltage is remaining around 24 volts for a long period - then you could have connector problems, clean and tighten all connectors. I use a fiberglass electronic cleaning brush, as contact cleaners leave residue that interfere with electrical connections. The control module is simple and can be replaced with only a 24 volt relay without the kick start feature or Brake. If you want the brake then you can use two 24 volt relays still no Kick Start. For those of you who know electrical, below is circuits I developed to replace the controller. This diagram will also give you a better understanding on the Razor circuit. NOTE : This is not a schematic diagram of the Razor E100 Control Module. I designed this circuit. for my Great Nephew's Scooter. 1. The Brake is a normally closed switch that opens when you squeeze the Brake handle. 2. The throttle is two normally open switches that close when you turn the throttle. 3. The Kick Start circuit is described in the Diagram below. 4. The resistors values may need to be tweaked for best performance.

Replace the Red Illuminated Light On/Off SPST Rocker Switch 15A/250V 30A/125 - Switch number SWT-102050 should be available at most scooter repair stores or online scooter repair for about $6.00. Black wire goes to the Brass terminal lug. when removing the wires mark the location as Top, Center and Bottom and place the Black wire on top with the brass terminal. to Search Online Type 'scooter repair SWT-102050' you will see a multitude of choices

No. The switch should be off before connecting the charger. You can download a manual from Razor here... http://www.razor.com/customer-care/owners-manuals/

Probably needs a new battery. They can only be recharged a set number of times.

You might still be under warranty. If so follow the instructions on the box. If you do not have a warranty, try a different outlet in your house. If this doesn't work, look up your model number and then battery on eBay and Amazon. Hope this Helps You, if it does be safe.

check the battery that is most likely what's wrong

Go to Home Depot and get a nut and lock washers. And double nut the axle with the lock washers.

I would like to have the instructions to the game of Mad Dash three minutes across America.

razor hasnt been charged for a week as i needed a new charger i had 1 scooter charging over night yet still nothing , i bought a new charger its showing green on the light do i have to wait till it shows red and then wot if it doesnt still work

What is the problem? It just says the name of the scooter.....

Most equipment running on rechargeable batteries have one thing in common: if you let the battery sit there for long periods of time without recharging, the charger is not made to bring the battery back up to spec. The battery pack, if it is still good, needs a "kick" or "boost" from some other strong supply to get it started. The other solution would be to replace the battery pack all together. If you have a friend with a similar scooter, you can try your new charger on his scooter to see if it works. Hope this helps!

MOST LIKLEY BATTERY THEY CAN ONLY BE CHARGED LIKE 3000 TIMES OR SO

On the bottom left side on the black compartment there is a red on/off switch, but when turned on you just turn the RT handle like a motorcycle and it will go. Make sure you helmet is on and keep it under 60, tickets are expensive these day's.

We had the same problem that I found to have a very simple fix. It seems all that needed to be done was hold in the reset button a few seconds while the battery charger was plugged in and the light on the charger turned to red and the battery charged again. Seems like too easy of a fix but it worked for my kids scooter.

Hi... My son hasnt used his Razor E100 for nearly a year as couldnt find the charger.. I finally found it and as soon as I plugged it in the plug was showing green light as that it was fully charged... When we turn the unit on it lights up but its dead... Where can I get the cheapest battery (and does it have 1 or 2)? Or you mention a reset button? Many Thanks...