20 Most Recent Nordic Track C2400 Treadmill Walking Deck - Page 9 Questions & Answers

Hi There, I can't say I know this particular model, but most lift motor assemblies have 3-wires to drive Up and Down windings, and then 3-wires to return a small location signal that gets measured inside the lift gearbox(0-5vdc), and sent as a sample voltage to the upper console to tell it where the lift motor is currently positioned. This pot, or potentiometer, can get dirty, greasy, fail completely, or lose connections inside the gearbox. Do NOT apply 110vac to the pot wires by mistake, as smoke will be the result, oh, and a 13lb boat anchor of a lift assembly ;o) If you have a DMM or a way of checking resistance, you can contact jatinah electronics for further help. Good Luck!

This sounds like there is an inadequate power supply to the panel circuit. Check that the batteries are properly seated in the battery compartment. Also, check that the batteries are not low or dead, as it could be that they are seated properly but not providing the necessary charge to the panel when you switch it on.

Check that the incline plus switch is not jammed or likely there is a defect in the panel circuit causing plus incline to be repeated. This needs to be trouble-shooted by removing and testing the panel circuit.

sound like the console is bad and may need replaced

could be a bad console

they vary from machine to machine.mostly metric

check youtube.com and search Nordic Track belt. There will likely be a video from Nordic Track to show you how to do it.