20 Most Recent
Jl Audio 10W6v2 Car Subwoofer - Page 3 Questions & Answers
The surround on my JL
most replacement parts can be found on ebay such as the refoam kit for the w7 an the center dome cover.
Car amp ohm light on
Hi, Most car amps run on 4 ohm or 8 ohm. Don't use larger ohm rated speakers on your system you can damage your amp. Also check that speakers are connected properly + to + and - to - (polarity is wrong) check wires for shorts or grounding too. Good luck
My whole system is working,
The most likely solution is that your voltage is dropping too much and the amp is going into protect mode to save itself because of the lack of power. Double check fuses in the amp first and then on the power cable and third make sure all the connections are solid, i.e. ground and power wire. Another thing might be to check that you didn't switch the polarity by connecting negative and positive wires to their opposites.
I have a 1200 watt
Turn down the volume or power settings on it since its pulling too much power and shutting off for a few sconds to keep from blowing. Depending on the amp and speakers your using dont bridge the channels. If it won't come out of protect mode then unhook everything and just hook power, ground, and remote and wee what happens. If it comes on again and stays on then amp is blown.
Which amp goes with 2 jl audio w3v3 4 ohm
Choosing a amp isn't always easy but it first begins with what you want.
--RMS of the speakers is what you want to use to find your amp.
That's going to tell you what watt's your speakers can REALLY handle @ 4 ohms.
--Also what you want to spend $$$ will determine how clear it sounds.
--I prefer a Rockford Fosgate amp for base and kenwood for highs.
--Also look at the RMS watt's rating to find the proper power and go a bit beyond what you want so that the amp performs with ease.
--Last but not least you chose the amp for how many speakers you are going to connect to that amp. For example if you are using 2 JL audio 12" for subs, then a mono amp is perfect. But if you are connecting 4 speakers, you should begin to find the amp with four channels so that you obtain left, right , front and rear sound.
Not finding what you are looking for?