Sharp AR-5320 Black and White Copier - Answered Questions & Fixed issues

improper cartridge (destination error,life cycle error

This was a hard one to find, but click on the below link and its the 5th one down -

Sharp AR-5320 driver

thx, if this solution helps please rate :)

What motor are you talking about the fuser motor, paper draw motor, the finisher motor, the transfer motor, the drum motor, the developer motor, corona wire transfer cleaning motor. I can go on. Replacing developer and toner has nothing to do with the motor running, Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Man mean maintenance signal.
Reset : # - Interrupt - C -interrupt press 14 press start key.
If you are not fix try next way.
# - Interrupt - C -interrupt press 16 press start key.

Check fuser unit for rollers or exit sensor problems. Rectify the problem if its gear and replace. Then reset with code 14.

Sharp AR-5320 photocopier/printer is in share network. for each printing command ,its asking to install driver.and its taking more time for printing..

how to reset the toner chip as it is costaly

hi dear may you dont have put the origenal document proper or may be blank, just put writing side down on the glass or if u are using ADF put the writing side up side,
thanks

Coppy light

Maybe? https://www.youtube.com/watch?v=qchhmaRXTn8

sim 14

go to www.sharpusa.com They have drivers there.

enter sim 14

Copy lamp error Replace the power unit. Check the copy lamp ON with SIM 5-3. Replace the copy lamp. Replace the inverter. Replace the MCU PWB.

enter sim 16

Make sure all the doors are closed & the toner catridge is full

it depends the how the machine was set but normally you can copy up to 50,000 pages

i hope its L4.If it is showing L4 it means the main motor is locked(failing to move) Check all the moving parts including the drum unit, developer unit, main drive unit and fuser unit if they are moving freely. If they are moving freely change the main motor

Enter sim 14 if not help check thermostat in the fusing unit

Copy lamp error, Replace the power unit. Check the copy lamp ON with SIM 5-3. Replace the copy lamp. Replace the inverter. Replace the MCU PWB